Table of Contents
Advertisement
If the axle, slotted gear and sprocket assembly is
disassembled,
mark down the positions of the parts
as they are removed. The drive wheel and sprocket
positions in relation to the slotted gear determine
which direction the spreader plate will spin. Be sure
to reassemble them in their original positions. (Refer
to figure 4 on page 6.) Use shim washers (Ref. no.
21 on pages 14 and 15) as needed for minimum
backlash.
Add grease to gear and sprocket.
If the agitator hairpin becomes damaged or worn it
can be replaced. See figure 16.
SPROCKET
J
SHAFT
HAIRPIN
FIGURE 16
PROBLEM
CAUSE
CORRECTION
Flow rate is not accurate.
. Flow controls out of adjustment.
1. Adjust the flow control bracket as
described at the end of page 8.
Material will not flow out of bottom of
1. Closure plate in bottom of
1. Change the flow control setting
hopper properly,
hopper is not open enough,
to match the application
chart.
2. Material is clumping at bottom
2. a. Stir or sift to break up clumps.
of hopper,
b. Wait for drier weather.
12
- Quick Links:
- Parts
Hide quick links:
Advertisement
Table of Contents
