Summary of Contents for Fisher & Paykel DD24 Series
Page 2
Safety and warnings Operating instru_;tions (ontrois (modelb witls irso IL,,£D) Controls (modells witlh IL,£D) Wash program chart Caring for your dinnerware Dishwasher standards test Loading suggestions Detergent dispenser Water softener Rinse agent dispenser Option adjustments User maintenance instructions Fault €:odes Warranty and service SAVE THESE INSTRUCTIONS The r_o(/e/...
Page 4
Safety and warnings }'our DishDrawer has been carefully designed to operate safely during normal dishwashing procedures, Please keep the following instructions in mind when you are using your DishDraweP. WARNINGf _ When using },our dishwashe8 follow bas£ precautions, including the following: Read aft instructions before using the DishDrawert The information...
Page 5
Safety warnings installation This DishDrawer ®must be installed and located in accordance with the Installation k_structions before it L_used. ff you did not receive fnstafiation k_struction sheets with your DishDrawer% you can order them by calling your Authorized Service Agent or from the Fisher & Paykel website, wwv_fisherpaykeLcom, Installation and service must be performed...
Page 6
Safety and wamings Maintenance Do not repair or replace any part of the apph'ance or attempt any serv£ing unless specificaNy recommended in this user guide. We recommend that you carl an Authorized Service Agent° Keep the floor around your appliance dean and dry to reduce the possibility of stippingo...
Page 8
Operating instructions - ControB {mode s withnoLCD) The Keylock feature disables all the buttons on the DishDraweP. To activate, press and hold the _/@ button until you hear one beep (3 seconds), The light above the _/@ button is lit when Keylock is activated. To cancel the Keylock feature, press and hold the _/@ button until the light above the _/@...
Page 10
instructions - Controls {mode s w th LCD/ Operating Keybck [he Keylock feature disables all the buttons on the control panel To activate, press and hold the _ button until you hear one beep (3 seconds). The _ symbol appears in the electronic display when the Keylock feature is activated.
Page 11
Operating instructions - Operation Load dishes Start Remove all food scraps and load the dishes. Close the drawer and press the H_ button. Finish Add detergent Check rinse agent The DishDraweP _ will beep six times to Press the _ button indicate the end of the wash program.
Wash program chart Heavy Normal Fast DeJicate Rinse Heavily soiled Disheswith Lighdy soiled Lightly soiled and Preventsodors and pots, pans and noh'_Tal soils dishes, heat sensitive soils drying on dishes. dishes, fbr optimum crockery. wash and dry performance, pre--wash 1 pre--wash 1 pre--wash pre--wash...
Caring for your dinnerware The combination of high temperatures and dishwasher detergent may cause damage to some items if they are washed in the DishDrawePL Remember, if in any doubt about any aspect concerning items washed in the DishDrawer _'_, follow the instructions from the manufacturer the items, or wash the item by hand.
Dishwasher standards test The DishDrawePs are tested to various standards for both wash and dry performance, The following are loading pattern diagrams, detergent quantities and rinse agent quantities used for the DishDraweP. Detergent quantities 5g (pre-wash) per drawer lOg (main wash) per drawer Water softener setting Adjust the water softener to match the water...
Racking features Cudery basket Mix spoons, knives and forks within each section to stop cutlery nesting together. Most cutlery is placed with the handle pointing down. For your safety, knives and sharp utensils should have their handles up. Small light items like baby bottle teats are best placed under the anti-nesting grids to prevent them from being displaced.
Page 16
Backing features AdjustaNe racks You can adjust these independently of each other to any height: Fold up to unlockthe rack. Adjust the height to suit by sliding up or down. Fold down to lock in position. Fold the racks away if you need the space. Glass supports These clip on the rack wires to give your tail...
Loading suggestions When [oading your DishDrawer, make sure that you place items so that water coming from the rotating spray arm below can reach all areas (performance wiI[ be reduced if it can't) nothing blocks the water from getting to items on the adjustable racks you place bowls and pots with their openings facing down...
Page 18
l!!{!ii!Sli Loading suggestions HowNOT to loadyourDishDrawe¢ Overcrowded and wash water will not The plates are nesting together and wash reach some of the dinnerware, water may not get througL Cups, glasses and bowls must have their Ensure cutlery are not nesting or stuck openings facing down.
Detergent dispense OMy use powdered detergent recommended for domestic automatic dishwashers in the detergent @:spenser° Dishwasher detergents are strongly a&ah_ne and can be dangerous ff swMtowedo Avoid contact with skin and eyes° Keep chiMren and infirm persons away#om the DishDrawer ®...
Page 20
Detergent dispense Detergent quantities The detergent quantities recommended beRoware for individuaRdrawers. Hard (>150ppm or >ggpg) Medium (100-150ppm or 6-9gpg) Soft (<100ppm or <6gpg) Heavy Normal Delicate _ No detergent is required in the pre wash compartment for the Fast wash program. Hard water situations Soft water situations...
Page 22
Water softener (DD24, H m ode s on y) The watersogenermust alwa_sbe filled withgranular s alt made espedaIly f or d_:shwasher water so_ening systems° Wedo not recommend the use of cooking satt like ruble satt, rock satt or pallets as they may contain impurities that w_"N impair or diminish the byeof the water so_ene_ The salt reservoir Water softening can only take place when there is salt in the reservoir.
Rinse agent dispenser We highly recommend the regular use of liquid rinse agent to give the best drying results. Rinse agent gives a streabfree, sparkling clean Iookto glass and chinaware. In addition, prevents metal from tarnishing. The rinse agent dispenser is on the inside of the drawer, located underneath the detergent dispenser.
Page 24
Option ad ust ' ents The following options can be adjusted to suit your preferences: Rinse agent setting Red uce the Rinse agent setting if there is excess foam after a wash program, Increase the Rinse agent setting if dishes are wet or streaky after a wash program. Water softener setting (DD24°H models...
User maintenance Cleaning the surfaces We do not recommend the use of the following cleaning aids on your D_shDrawer ®as they may damage the surfaces: Plastic or stainless steel scouring pads Abrasiv6 solvent, househoM cleaners Acid or atkaline cteaners Hand washing #quids or soap Laundry detergents...
Page 28
User n'saintenance instructions Cleaning the drain filter, sisray arm and filter Is[ate We recommend that the drain filter is cleaned whenever there is evidence of food particles, The spray arm and filter plate may need cleaning about once a month in normal use or more often should the need arise.
Page 29
User _aintenanc@ CJeaning the spray arm and fiJter p_ate Ensure the DishDraweP is cool before you start cleaning and follow the instructions removing the drain filter and spray arm. I{_ Unclip the glass supports from the rack wires and fold all the adjustable racks away, so that they are upright and dose to the top,...
Page 30
Wash program unsuitable Refer to the'Wash program chart'for Unclean dishes for the load. suitable wash program, or the soils were too heavily baked on and dishes may need soaking. Spray arm unable to rotate. Ensure no items are obstructing the spray a!m pat(_ DishDrawer _'_ overloaded/ Refer to the section on loading.
Page 31
Continuous Afault h as o ccurred. Refer tothe'Fault codes' section. beeping Intermittent DishDrawe¢ _isinpause Close the DishDrawe¢ _ and press theHt beeping mode. button. Power supply isnot Connect the power supply. DishDrawe¢ _will connected. not start The drawer isnot c losed Ensure thedrawer isfirmly c losed. is on.
Page 32
Fau t codes How to recognize a fault code When a fault has occurred, the DishDraweg will continuously beep every second. The fault code will be displayed on the electronic display for models with LCDand on the wash program selector for models with no LCD. Eachfault code is shown in the following chart, How to attend to a fault code...
Page 33
Fau t codes Flood switch has been Turn the water and power supply to the activated, DishDraweP off and call your Authorized Service Center. HFAVY NORMAL FAST DEUCATS RtNS_ _,,, Motor problem. Call your Authorized Service Center. HSAVY NOR_'V,_L FAST DSUCA_E RINSE Temperature...
Page 34
Fau_tcodes il!! ® Fill Fault 1 Turn the DishDrawe¢ _water supply on, 2 Ensure the spray arm is placed on the impeller and can rotate and if the DishDrawe¢ '_is fuji of water, it will HEAVY NOR&'_AL F_SY DEMCAT_ R_NSE need to be emptied manually, 3 Call your Authorized...
Warranty and service Before you ca[[ for service or assistance Check the things you can do .vourseff, Referto the installation instructions and your user guide and check that: "_ your product is correctly installed you are familiar with its normal operation, If after checking these points you still need assistance, please refer to the Service &...
Need help?
Do you have a question about the DD24 Series and is the answer not in the manual?
Questions and answers