Loading The Tool With Nails; Setting Depth; Nailing Or Stapling - Craftsman 315.115120 Operator's Manual

LOADING THE TOOL WiTH NAILS
See Figures 3 - 5.
[] Remove battery pack from the tool.
[] Hold too! upside down; squeeze latch and s(ide base
open.
[] P(ace nails in the center of the channe( with "T" head
sitting on the s(ot base. Close base while making sure
ha(( stdp stays upright in channel.
NOTE;: There are two channels for the nai(s. Use the
sma((er channel for na(Is sized 3,/4 in, to 1 in, Use the
(arger channe( for na(Is s(zed 1-1,/4 in. Refer to mo(d(ng
on the too(,
[] Make sure that the (atch (s secure(y (ocked in p(ace.
[] Reattach battery pack to tool.
F(g. 6
NAILING OF{ STAPLING
See Figure 7.
[] Hold handle firmly with magazine flat to workplece
forming a 90 ° angle.
[] Press the activation foot of the nailer/stapler down
against the workpiece to disengage the safety
interlock, The activation foot must be depressed before
the lock-off button and switch trigger are depressed,
[] Depress the lock-off button from either the left or right
side and pull switch trigger to drive nail or staple.
[] Release the switch trigger and activation foot before
dr(ving another nai! or staple.
NOTE;: You must release the activation foot and
switch trigger after each nail or staple to reset the too!.
The tool w(l! not fire another staple or nail until the
activation foot and switch trigger are released.
(
SETTING DEPTH
See Figure 6.
[] Rotate the depth adjustment knob clockwise to use
more force for nai(ing or stapi(ng,
[] Rotate depth adjustment knob counterc(ockwlse to use
(ess force for nai(ing or stapling,
[] Test on a scrap piece of the same mater(al you are
using to achieve the desired results.
NOTE: Harder materials wi(( require more force to ha((
or stap(e.
12
Fig. 7