Advertisement
TOOLS
REQUIRED
FOR ASSEMBLY
(2)
7/16" Wrenches
(2)
1/2" Wrench
(1)
Pliers
(1)
Hammer
STEP 1:
(SEE FIGURE 1)
*
install a 1/4-20 x 1" hex bolt (39) and a 1/4" hex nut
(25) in each bag arm channel and then place a 1/4"
washer (43) onto the end of the bolt.
43
4
25 _
39
FIGURE 1
STEP 3:
(SEE FIGURE 3)
*
Secure each bag arm channel to the side of the
sweeper housing with a wing nut (31) and a washer
(43) installed on the bolt assembled in step 1.
*
insert a pivot rod retainer (30) down into the end of
each bag arm channel.
*
install a compression spring (32) into the bottom of
each of the pivot rod retainers to secure them to the
bag arm channels.
43
FIGURE
3
STEP 2:
(SEE FIGURE 2)
*
Slide the bag arm channels (4) into the sweeper
housing as shown in figure 2. Secure them to the
sweeper housing with a 5/16-18 x 2-1/2" hex bolt (15)
and 5/16" nylock nut (21). Tighten bolt until snug. Do
not overtighten.
STEP 4:
(SEE FIGURE 4)
*
Attach the drawbar (14) to the sweeper by fastening
a drawbar bracket (8) above and below the drawbar
using two washers (68), three 5/16" x 2-1/2" hex bolts
(15) and 5/16" nylock nuts (21).
21
FIGURE 2
5
FIGURE 4
Advertisement
