Service Safety - Craftsman 320.28160 Product Manual

Do not force the tool. Use the correct tool and blade for your application.
The correct tool and cutter will do the job better and more safely at the rate
for which it is designed.
Disconnect tools before servicing; when changing accessories, such as
blades, bits, cutters, and the like.
Store idle tools out of the reach of children and other untrained people.
Never leave the tool running unattended; turn the power off. Don't leave
the tool until it comes to a complete stop.
Always maintain tools with care. Keep cutting tools sharp and clean. Properly
maintained tools with sharp cutting edges are less likely to bind and are easier to
control. Follow all instructions for lubricating and changing accessories.
Check for damaged parts. Before further use of the tool, a guard or other
part that is damaged should be carefully checked to determine that it will
operate properly and perform its intended function. Check for alignment of
moving parts, binding of moving parts, mounting, and any other conditions
that may affect its operation. A guard or other part that is damaged should be
properly repaired or replaced.
Direction of feed. Feed work into a blade or cutter against the direction of
rotation of the blade or cutter only.
SERVICE SAFETY
• Tool service MUST be performed only by qualified repair personnel. Service or
maintenance performed by an unqualified person could result in a risk of injury
• Use only identical replacement parts when servicing a power tool.
• Follow the instructions in the Maintenance section of this Product Manual.
Use of unauthorized parts or failure to follow Maintenance Instructions may
create a risk of electric shock or injury.
SPECIFIC SAFETY FOR THE ROUTER TABLE
• Read and understand the router table and the instructions and warnings
in the product manuals for the router table and the router, Failure to follow
all instructions and warnings may result in serious personal injury.
Fully assemble and tighten all fasteners required for this table and for
mounting the router to the table. Do not use the router table until all assem-
bly and installation steps have been completed. Before each use, check the
stand and the router to make sure that all fasteners are still tight. A loose
stand is unstable and may shift in use.
• Unplug the router before installing it into the table, Turn off the router-table
safety switch controlling power to the the router, or unplug the router before
making adjustments or changing accessories, such as bits or cutters.
28160 Manual_Revised_07-0228 Page 9