Craftsman 171.254841 Owner's Manual page 8

FIGURE 3, ASSEMBLY DETAIL
ASSEMBLY CETAL
tighten fasteners at this time.
I I The extensions are identified with
I
NOTE
either an "R" for the RIGHT SIDE extension (29LCN-
988) or an "L" for the LEFT SIDE extension (29LCN-
989). The "R" or the "L" will be found on one of the
bent down or bent up ends of the extensions.
4. Assemble one of the RIGHT SIDE extension
braces (29LCN-988) to the table leg and the exten-
sion using #10-32 x 1/2" long truss head machine
screws and #10-32 hex "KEPS" nuts, as shown in
Figure 3 and Figure 3, Assembly Detail.
5. Assemble one of the LEFT SIDE extension braces
(29LCN-989) to the table leg and the extension using
#10-32 x 1/2" long truss head machine screws and
4'10-32 hex "KEPS" nuts, as shown in Figure 3.
6. While pressing down on the extension, tighten all
of the fasteners using the following sequence:
a. Those holding the extension to the table top.
b. Those holding the extension braces to the legs.
c. Those holding the extension braces to the
extension.
7. Position the other extension alongside the left side
of the table top so that the miter slot in the extension
lines up with the miter slot in table top, as shown in
Figure 4.
FIGURE 4
8. Assemble a #<10-32 x 1/2" long truss head
machine screw and _'10-32 hex "KEPS" nut at each
of the holes in the extension, as shown in Figure 4.
DO NOT tighten fasteners at this time.
9. Assemble the other LEFT SIDE extension brace
(29LCN-989) to the table leg and the extension
using #10-32 x 1/2 long truss head machine
screws and a #10-32 hex "KEPS" nuts, as shown in
Figure 4.
10. Assemble one of the RIGHT SIDE extension
braces (29LCN-988) to the table leg and the exten-
sion using #10-32 x 1/2" long truss head machine
screws and #10-32 hex "KEPS" nuts. as shov,.n in
Figure 4.
11. While pressing down on ti_e extension, tighten all
of the fasteners using the following sequence:
a. Those holding the extension to the table top.
b. Those holding the extension braces to the legs.
c. Those holding the extension braces to the
extension.
12. Set the router table right-side-up on the floor and
check that the extensions are parallel and even with
or slightly below the top of the table.
In no case are the extensions to be higher than
or above the top of the table top. They could
interfere with the workpiece during routing and
cause a condition that can result in possible
serious injury.
13. If the extensions are higher and!or not parallel.
then loosen the fasteners hoi0ing the extensions to
the braces and the table top. and reposition the
extensions so that they are parallel.
14. Securely TIGHTEN all fas:eners again.
15. To double check, slide a fat piece of wood along
the top of the table in all directions. Make sure that
the edge of the wood moves freely without contact-
ing the edges of the extensions,