Table of Contents
Advertisement
Quick Links
OWNER'S MANUAL
DieHard.
BATTERY CHARGER/MAINTAINER
1.5 Amp
Fully Automatic
Float-Mode
Monitoring
Model No.
200.71220
CAUTION:
Read and follow all Safety
Rules and Operating
Instructions
Before Every Use of this Product.
SAVE THESE INSTRUCTIONS.
Sears_ Roebuck and Co v Hoffman Estates_ IL 60179 U.S.A.
0099CO0308/_403
Advertisement
Table of Contents
Related Manuals for DieHard 200.71220
Summary of Contents for DieHard 200.71220
- Page 1 OWNER'S MANUAL DieHard. BATTERY CHARGER/MAINTAINER 1.5 Amp Fully Automatic Float-Mode Monitoring Model No. 200.71220 CAUTION: Read and follow all Safety Rules and Operating Instructions Before Every Use of this Product. SAVE THESE INSTRUCTIONS. Sears_ Roebuck and Co v Hoffman Estates_ IL 60179 U.S.A.
-
Page 2: Table Of Contents
Warranty ........................Important Safety Instructions ................Personal Safety Precautions ............... Before using your Battery Charger ............... Quick disconnect harness ................Plugging _tin ....................Using an extension cord ................Preparing your battery to be charged ..............Using your Battery Charger ..................Setting Controls ................... -
Page 3: Important Safety Instructions
WARNING: Toreduce t he risk of HELP US HELP YOU -- explosion, explosive gases, or injury Remembe_ while using your battery charger, follow • Place charger as far away from the the precautions listed below: battery being charged as the charger •... -
Page 4: Personal Safety Precautions
Personal Safety Precautions For your own personal safety, please follow the following precautions: • Take care not to drop any metal tool • Wear complete eye and clothing or metal object onto the battery. This protection when working with lead- acid batteries. -
Page 5: Before Using Your Battery Charger
It is important to understand your charger's requirements. This section will tell you about your charger's electrical requirements and how to prepare a battery for charging. QUICK DISCONNECT HARNESS To permanently attach to a small battery (i.e. motorcycle), connect the red POSITIVE harness wire eyelet to the POSITIVE battery terminal. -
Page 6: Preparing Your Battery To Be Charged
It is important that you read and follow these guidelines while you are preparing to charge your battery. • Make sure that you have a 12 volt or cell caps while charging, and recom- 6 volt lead-acid battery. Set the mended rates of charge. -
Page 7: Inside Vehicle
Follow these steps when battery is in- Follow these steps when battery is outside of vehicle. stalled in vehicle. A spark near battery may cause battery explosion. To re- a)Check polarity of battery posts. Positive duce the risk of a spark near the battery: battery post usually has a larger diam- eter than the Negative post, a)Position AC power cord and DC output... -
Page 8: Operating Instructions
OPERATION INSTRUCTIONS The Red LED indicates an overload condition. Common causes are short- a)Set the 6 and 12 Volt selector switch to ing of the battery clamps, reverse- match the voltage of the battery being polarity connection to a battery, and charged. -
Page 9: Maintenance And Care
keep your battery charger working properly for years: THIS CHARGER IS NOT SUBJECT TO 1.CLean the clamps each time you are REPAIR. finished charging. Wipe off any battery fluid that may have come in contact w_th RETURN CHARGER TO PLACE OF the clamps to prevent corrosion.
Need help?
Do you have a question about the 200.71220 and is the answer not in the manual?
Questions and answers