Craftsman BACKWALL WITH METAL PEGBOARD Operator's Manual page 4

f
WARNING: Backwallwith Metal Pegboard is only to be
attached to one of the following Workbenches:
59741, 59742, 59746
NOTE: To assemble the Backwall,the drawers and top must
first be removed from the workbench.
DRAWER REMOVAL AND INSTALLATION:
FRICTION DRAWERS:
• Empty the drawer.
• Fully extend the drawer. Then push it back a fraction of
an inch.
• Insert a screwdriver into the slot in the slide and
depress the stop until it clears the lance.
Slot f Stop
Lance
Lubricate
Repeat the procedure for the other slide. Remove the
drawer.
To reinstallthe drawer, pry the stop far enough out to
engage the lance (3/16" to 1/4") and push the drawer
onto the slides until the stops pass over the lances.
BALL BEARING DRAWERS:
Empty the drawer.
• Fully extend the drawer.
• Lift the release lever on the rightside, while depressing
the lever on the left side and pullthe drawer out to
remove.
Lever
• To reinstall, carefully align the slides and slowlypush
the drawer into the unit until the drawer stops.
TOP REMOVAL:
NOTE: When removing top, save the screws to reattach after
backwall is assembled.
Remove and save the screws from the wood top.
Remove top from workbench base.
f
STEP1
AA (2)
DD (2)
EE (2)
Remove and reuse topfastenersinback of
workbench.
Attach A(2).
Fingertighten.
__ Existing
hardware
/
/
FRONT
A(2)
J