Table of Contents
Advertisement
WARNING:
BE SURE to read and understand all instructions
in this
manual before using this product,, Failure to follow atl instructions
may result in
hazardous radiation exposure, electric shock, and/or bodily injury.
,_
CAUTION:
Do not attempt to modify the performance
of the laser device in
any way., This may result in a dangerous exposure to laser radiation
WARNING:
LASER RADIATION.
Do not stare into beam, CfassII laser
product.. Turn the laser beam on only when using this tool
_Ik WARNING:
Use of controls, adjustments, or the performance of procedures
other than those specified in this manual may result in hazardous radiation exposure,
_k WARNING:
The use of optical instruments
such as, but not limited to,
telescopes
or transits to view the laser beam wilt increase eye hazard.
This measuring toot has a built-in laser light. The laser is a ClassiI
and emits
output power of a maximum 1roW and 635 wavelengths
These lasers do not
normally present an optical hazard. However, do not stare at the beam, as this
can cause flash blindness,
The following label is on your laser measuring toot., It indicates the location
from which the laser measuring tool emits the laser light, Be aware of the laser
light location when using the tool, Always make sure that any bystanders
in the
vicinity of use are made aware of the dangers of looking directly into the laser,
o
Do not remove or deface any product
labels.
o
Avoid direct eye exposure.
The laser beam can
cause flash blindness,
AVOID EXPOSURE
Lar_er
r_dt_tl_
Is oral{ted f_m
_hls *_port_to
.
The laser measuring
toot is not a toy. Always
__
keep it out of the reach of children. The laser
_*_..ADIA_O..OO___"_".._"TgB_
light emitted from this device should never be
.................................
_v r_
directed toward any person for any reason ................
Do not operate the tool around children or allow
...........
children to operate the tool,,
Do not place the tool in a position that may cause anyone to stare at the
laser beam, whether intentionally or unintentionally,
o
Do not use on surfaces such as sheet steel that have shiny, reflective
surfaces
The reflective surface could reflect the beam back at the operator,,
Always turn the laser tool off when not in use. Leaving the tool on
increases the risk of someone inadvertently
staring into the laser beam,,
Do not attempt to modify the performance
of this laser device in any way
This may result in a dangerous
exposure
to laser radiation.
48277
Manuat_Revised_O9-0211
Page 3
Hide quick links:
Advertisement
Table of Contents
