Hitachi XP P9500 User Manual page 200

Use this parameter to place online, at one time, all the paths that pass
through a specific channel adapter port. The command will place online all
the paths that pass through the channel adapter port to which the path
with the specified AutoPATH_ID is connected. You can specify this
parameter only when the HDLM management-target device is the
Thunder 9500V series, Lightning 9900 series, Lightning 9900V series,
Hitachi USP, Hitachi AMS2000/AMS/WMS/SMS series, Universal Storage
Platform V/VM, and Virtual Storage Platform.
Specify the current AutoPATH_ID of the target path, which is displayed by
using the view operation. For details about the view operation, see
(Displays Information) on page
(000001 and 1 indicate the same AutoPATH_ID); however, when the
target AutoPATH_ID is 000000, enter 000000 or 0 for the parameter
value.
AutoPATH_IDs are re-assigned every time the host is restarted. Always
make sure that you use the view operation to find the current
AutoPATH_ID of the target path, before executing the online operation.
Example
-pathid AutoPATH_ID
Use this parameter to place a single path online.
Specify the current AutoPATH_ID of the target path, which is displayed by
using the view operation. For details about the view operation, see
(Displays Information) on page 6-29
(000001 and 1 indicate the same AutoPATH_ID); however, when the
target AutoPATH_ID is 000000, enter 000000 or 0 for the parameter
value.
AutoPATH_IDs are re-assigned every time the host is restarted. Always
make sure that you use the view operation to find the current
AutoPATH_ID of the target path, before executing the online operation.
-hbaportwwn HBA-port-WWN [-tid target-ID -hlun host-LU-number]
Specify this parameter to place online all paths connected to the HBA port
indicated by the specified HBA port WWN. If the -tid and -hlun
parameters are not specified, all paths on the specified HBA port WWN
are placed online. Only one set of values can be specified for the -
hbaportwwn parameter.
For HBA-port-WWN, specify the value of HBAPortWWN. The parameter is
not case sensitive.
6-12
The following example shows how to place online the paths connected
to the channel adapter port 0A. In this example, a path whose
AutoPATH_ID is 000002 is connected to the target channel adapter
port:
>dlnkmgr online -cha -pathid 000002
KAPL01057-I All the paths which pass the specified CHA port
will be changed to the Online status. Is this OK? [y/n]:y
KAPL01061-I 2 path(s) were successfully placed Online; 0
path(s) were not. Operation name = online
>
Command Reference
Hitachi Dynamic Link Manager User Guide (for Windows(R))
6-29. Leading zeros can be omitted
Leading zeros can be omitted
view
view