Table of Contents
Advertisement
Always follow all safety precautions
when
cleaning and servicing the Power-Mate ® .
Electrical Shock Or Personal
Injury Hazard
Disconnect
electrical
supply
before servicing
or cleaning the
unit. Failure to do so could result
in electrical
shock or personal
injury from cleaner suddenly
starting.
Although the dirt sensor feature in your
Kenmore Power-Mate ®is designed for years
of trouble free use, the passage of dirt
through the air passage system can coat the
lens causing the green light to come on and
stay on - never switching to red. When this
happens the lens must be cleaned.
Never use water or any cleaning
solution when cleaning the lenses.
The residue of the water or cleaners
will accelerate
the recoaUng of the
lenses and make cleaning
necessary
sooner.
TO CLEANTHE LENSES
1. Remove the
"_--=U
wands by press-
ing the quick
release pedal and
lifting up on the
wands.
2. As indicated by the illustration, the two dirt
sensor elements are located on the inside of
the swivel, approximately
31,_inches/90 mm
down, (note the arrows), Each element
should be cleaned periodically. To reach the
sensor elements, use a small brush such as
a bottle brush. Brush each sensor element
several times to remove dust and dirt,
Cross Section View
Ap_prox.
3 _ inches
or 90 mm
!_j
_.
_, R ing
_--Sensor
IL iL£io"on '
NOTE: Looking down inside the swivel you
will see a ring. The sensor elements are
located just slightly below this ring.
3. Reinstall the wands after cleaning the sen-
sors.
9
Advertisement
Table of Contents
