Turning The Power On - Sharp DV-HR300X Operation Manual

Turning the Power On

24
Turning the Power On
Press OPERATE on the remote
control or Recorder to turn on the
power of Recorder.
• When you turn on power, the HDD button
and DVD button on the front of Recorder
will blink. If either the HDD or DVD button is
blinking, system processing is in progress,
so wait until the button lights up.
• When the Recorder power is turned on for the
first time after purchase, the clock setting
screen is displayed. Follow the procedure
shown on page 26.
To Turn the Power Off
Press OPERATE on the remote
control or Recorder to turn off power.
• The HDD or DVD button on the front of
Recorder will go out, and the STANDBY
indicator will light up.
• If you press OPERATE again immediately
after turning off, the Recorder may not turn
on. If this happens, wait a while and then
turn on power again.
About the Power Supply
• Do not unplug the power cord immedi-
ately after you plug it into the AC outlet
(less than about 15 seconds after
plugging in). In very rare cases, this
may cause the memory to revert to its
initial state, and all timer programmes
will be erased. If you pull out the power
plug while power is on, it will take a
while for the hard disc to get ready
when you turn on power the next time.
During this time you can only view live
broadcasts.
• If you turn on power in a low-tempera-
ture environment, only live broadcast
viewing is possible until the hard disc
(HDD) reaches its operating tempera-
ture.