Epson PowerLite 1730W User Manual page 78

Status lights (continued)
Light Status
Flashing
orange
Red
Flashing
orange
Flashing red
Flashing red
Flashing red
Solving Problems
78
Description
Rapid cooling is in progress. Although this is not an abnormal condition,
projection will stop automatically if the temperature rises higher. Make
sure there is plenty of space around the projector for ventilation, and that
the air filter and vents are clear. If you're using the projector above 4900
feet (1500 m), turn on High Altitude Mode; see page 64.
The projector is overheating, which turns the lamp off automatically.
Wait until the cooling fan stops, then unplug the power cord. Plug the
power cord back in and press the
temperature is not above 95 °F (35 °C), and there is plenty of space
around the projector for ventilation. If you're using the projector above
4900 feet (1500 m), turn on High Altitude Mode; see page 64.
The air filter or vent may be clogged. Clean them or replace the air filter
as described on page 69.
If the projector continues to overheat after you clean the air filter, the
problem may be caused by damage to the cooling fan or temperature
sensor. Contact Epson for help as described on page 87.
Warning: Except as specifically explained in this User's Guide, do not
attempt to service this product yourself.
It's time to replace the lamp. See page 70 for instructions. If you continue
to use the lamp after the replacement warning, there is an increased
possibility that the lamp may break.
The lamp may be burnt out. First make sure the lamp cover is securely
installed. If that's not the problem, let the lamp cool, remove the lamp,
and replace it as described on page 70.
The air filter or vent may be clogged. Clean them or replace the air filter
as described on page 69.
If this does not resolve the problem, contact Epson as described on
page 87.
Power is cut off because of an internal problem. Unplug the power cord
and contact Epson for help, as described on page 87.
The auto iris is malfunctioning. Unplug the power cord and contact Epson
for help, as described on page 87.
P
Power button. Make sure the room