Operating; Anti-Engine Inclination; Stopping; Stopping Engine - Cub Cadet LT1042 Operator's Manual

• Hold the brake control lever (A) on the equipment
against the handle (B) on the equipment.
• Pull the recoil starter grip (C) slowly until you feel
compression, then pull fast and steady.
Figure 11
A. Brake Control Lever
B. Handle
C. Recoil Starter Grip
Warming up
CAUTION: Allow engine to warm up before loading.
This will allow oil to reach all the engine parts, and
the piston clearance to reach design specification,
before the engine is ready for loading.
• After engine starts, warm up the engine, run it for a
few minutes.

OPERATING

Anti-engine inclination

• This engine will operate continuously at angles up
to 30°in any direction.
• Refer to the operating instructions of the equipment
this engine powers.
• Because of equipment design or application, there
may be more stringent restrictions regarding the
angle of operation.
CAUTION: Do not operate this engine continuously
at angles exceeding 30° in any direction. Engine
damage could result from insufficient lubrication.

STOPPING

STOPPING ENGINE

Release the brake control lever (A) on the equipment
from the handle (B) on the equipment to stop the engine
and the cutting blade.
A. Brake Control Lever
B. Handle

ADJUSTMENT

Engine Speed Adjustment

NOTE: Do not tamper with the governor setting or the
carburetor setting to increase the engine speed. Each
carburetor is adjusted at the factory with either a cap or
stop plate installed on the mixture screw. Any
adjustments must
Kawasaki dealer.
30
Figure 12
be performed an authorized