Cub Cadet Sc2450 Operator's Manual page 8

Step 3. Replace the hardware removed from the
lower handle. Tighten all four handle
(two on each side of the handle
assembly) nuts with 1/2" wrench or
socket.
Remove
Pivot
Note: Use the same hole in each strut. The three holes in each strut allow for handle
adjustment up and down.
Step 4. Raise the complete handle assembly
until it lines up with one of the mounting
holes in the struts. Put the carriage bolt
through the struts and then through the
handle. Place the saddle washer on the
bolt and then fasten with the wing nut by
hand. Complete this step by attaching
the other side of the handle to the other
strut
8