Craftsman 113.238180 Owner's Manual page 17

1t. Adjust the tool rest approximately 1/8" away from
the corners of the wood and 1/8'" above the center line.
Note the angted position of the tool rest base.
Lock the tool rest base and the tool rest,
TOOL REST
I/8"
WOOD
Look at the speed chart. Notice that a 2" square
turning up to 18" tong should run at 875 R.P.M. for
"roughing" Move the V-belt on the pulleys to the
slowest speed,
Rotate the wood by hand to make sure that the corners
do not strike the tool rest.
17