Turning Off The Projector; Focusing And Zooming Your Image; Adjusting The Height Of Your Image - Epson PowerLite 6110i User Manual

Epson PowerLite 6110i

Turning Off the Projector

When you're finished using the projector, follow the steps
below to shut it down. This extends the life of the lamp and
protects the projector from possible overheating.
Note: When the projector has not received any input signals for 30
minutes, it automatically turns off the projection lamp and enters
"sleep mode." This conserves electricity, cools the projector, and
extends the life of the lamp. If you want to start projecting again,
press the P Power button. If you are done using the projector,
unplug the power cord. To turn off sleep mode, see the
User's Guide.
Turn off this product when not in use to prolong the life of the
projector.
1. Turn off and disconnect any equipment plugged into the
projector.
2. To turn off the projector, press the P
Power button
3. When the P Power light is steady orange, you can unplug
the projector.
4. With Epson's exclusive Instant Off
cool-down period. When you're done, just unplug the
projector.
Caution: To avoid damaging the projector or lamp, never unplug
the power cord when the P Power light is green or flashing orange.
6
button twice.
Power
®
technology, there's no
12/07
Adjusting the Image and Presentation
The following sections describe how to adjust the image and
control your presentation.

Focusing and Zooming Your Image

Open the lens access door, then do the following:
❏ Use the
ring to sharpen the image.
Focus
❏ Use the
ring to reduce or enlarge the image. Move
Zoom
the ring toward the to increase the size, or toward the
W
to decrease it.
If the image still isn't large enough, you may need to move
the projector farther away from the screen. You can also use
the buttons on the remote control to zoom in on a
E-Zoom
portion of the image. See page 8 for instructions.

Adjusting the Height of Your Image

If the image is too low on the screen, you can use the front
adjustable feet to raise it.
1. Lift the front of the projector and turn the front feet to
adjust the position of the projected image.
T
Focus ring
Zoom ring
Turn to adjust
image height