Troubleshooting - Craftsman 320.48249 Owner's Manual

PROBLEM
Tone is heard
from Levet
System
Laser dot!line
is hard to
see.
Laser dot/line
is not
projected.
The tool can
not be leveled
nlll,i i
Laser dot/line
projected
is not level
Laser dot/line
projected
is not level
CAUSE
Batteries
are weak,
Working condition is
too bright.
The toot is too far from
the target,
Power switch
is not "on",,
The surface where
the tool is placed
is very uneven.
The X and Y bubbles
are not in the center
of vials.
The Z bubble is not in
the center of vial,
SOLUTION
ul_l,,,,,,,,i ii, i i i , ,ll,i/
Replace with fresh batteries.
Use laser enhancing glasses.
Get the toot closer to the target,
lU Ullll ,
Check to be sure the power
switch cover is in the full
down or "on" position,
u
Place the tool on an
comparatively horizontal surface,
Adjust the "X" and "Y" wheels
to make sure the X and Y
bubbles is are in the center of vials.
Adjust the "Y" wheels to make
sure the Z bubble is in the
center of the vial
12