Installing Drawers; Removing And Installing - Craftsman 706.366440 Operator's Manual

o _ F,± o
INSTALLING DRAWERS
Ball bearing slide = Pull slides and slide carrier out to fully
extended position (see illustration.) Hold the slide on the
cabinet while aligning it with the slide on drawer. Slightly
insert one side and repeat for the other side. Slowly push
drawer to its fully closed position to engage slide. Open
drawer and rectose to ensure proper operation.
slide carrier
slide
REMOVING AND INSTALLING SLIDES
, To remove the slide from the unit, first remove the
drawer.
After removing the drawer check to see if the unit has
rivets located on the front of the slide. To drill out rivets,
use a 5/32=in drill bit. The rivets will need to be replaced
with 5/32dn rivets.
To reinstall the slide in the appropriate position in the
unit, align front and back lances with mounting holes in
the side of the unit. Pull towards the front of the unit and
downwards until rivet holes in slide line up with holes in
the unit. The rivets will need to be replaced with 5/32dn
rivets.
For smooth operation, make sure the drawers are
matched with their original slides.
Drill out_
rivet