Panasonic CT-27DC50 Operating Instructions Manual page 10

REMOTE CONTROL OPERATION
Programming The Remote
The Universal Remote Control can be programmed to operate many manufacturers'
components, using the component function buttons for CABLE, DBS, VCR, or DVD. Follow the
procedures for programming your Remote Control with or without codes for the component.
Determine the manufacturer of the component and look in the table for the code.
With A Code
Confirm that the extemal component is plugged in and on.
Turn the component off.
Press the ACTION and POWER button, together, for at least 5 seconds.
Press appropriate component button on the Remote Control (VCR, DBS/CBL, or DVD).
Enter the 3-digit component code using the Remote Control numeric keypad (0 ~
9 buttons).
Press the Remote Control POWER button to test the component. If the procedure was
successful, the component will turn on.
Helpful Hints: Unsuccessful Code
If the component does not operate with the
Remote Control, repeat the procedure using
another code, (Some brands have multiple codes.)
If an incorrect code is entered, or if the procedure
takes onger than 30 seconds, the programm'ng!
willfail.
Without A Code
This procedure searches all codes and is called the "sequence method".
Confirm that the external component is plugged in and on.
Turn the component off.
Press the ACTION and POWER button, together, for at least 5 seconds,
Press appropriate component button on the Remote Control.
Press the [.] button to move forward to the next code. Press the [*] button to move
backward.
Press the Remote Control POWER button to test the component. If the procedure was
successful, the component will turn on.
Note: Repeat the above steps until the component code is found. It may take many
attempts before the correct code is found.
After the code is found, press the ACTION button to store the code.
CABLE BOX VCR DBS
El