Legacy Diskette A Or B; Large Disk Access Mode; Keyboard Features - Intergraph StudioZ GT RAX Setup Manual

48

Legacy Diskette A or B

To configure a floppy disk drive that has been added to or removed from your computer, highlight
the desired drive. Use the plus or minus keys to change the setting until it matches the installed
floppy drive. The BIOS supports 2.88 MB 3.5-inch, 1.44/1.25 MB 3.5-inch, 1.2 MB 5.25-inch,
720 KB 3.5-inch, and 360 KB 5.25-inch floppy drives. The default settings are 1.44 MB/1.25 MB
3.5-inch (for Diskette A) and Disabled (for Diskette B).
NOTE The 1.25 MB setting uses a 1024 byte/sector Japanese media format.

Large Disk Access Mode

If you are using a DOS operating system (MS-DOS, Windows NT, Windows 95, Novell DOS or
PC-DOS), set the disk access mode to DOS (default). If you are using a different operating
system, set this parameter to Other. Different operating systems require different settings. If you
are installing new software and the drive fails, change the selection and retry.
NOTE Change this setting only prior to formatting the system disk. Erratic system behavior
or file corruption can occur if this setting is changed during normal system drive use.

Keyboard Features

This parameter displays a submenu of options for configuring the features of the keyboard. Press
to display the option menu.
ENTER
Numlock
This option specifies the power-on state of the
settings are On and Off.
Key Click
This option enables or disables key clicks. The default setting is Disabled.
Auto-repeat Rate
This option configures the key repeat rate. Select from a range of 2 - 30 repeats/second. The
default setting is 30 repeats/second.
Auto-repeat Delay
This option configures the delay before keys start repeating. Select from a range of 1/4 to 1
second. The default setting is 1/2 second.
key. The default setting is Auto. Other
NUM LOCK