Sony BRAVIA KDL-40Z4100 Operating Instructions Manual page 14

Use tile TV as a monitor for your PC by connecting a HDI5-HDI 5 cable as shown below. Tiffs TV can
also be connected to a PC with a DVI or HDMI output. (Refer to the separate Quick Setup Guide.)
HD15-HD15
cable (analog
RGB)
Rear of TV
j,/_., BGE
/¢ _ s;:sJF, ............... g:
, %
Audio cable (stereo mini plugs)
• Connect the PC IN jack to the PC using an HDI5-
HDI5 cable with ferrite core (analog RGB) and audio
cable (see page 11 ).
• If the PC is connected to the TV and no signal has been
input from the PC for more than 30 seconds, the TV
enters the standby mode automatically (see page 53).
PC Input Signal Reference Chart
After connecting the PC to the TV, set the output signal froul the PC according to the supported resolutions
and timings indicated below.
VGA 640 x 480 31.5 6(} VGA
640 x 48(1 375 75 VESA
720 x 4(1(I 31.5 70 VGA-T
SVGA 8tXI x 6tXI 37.9 6(1 VESA Guidelines
8(X) x 600 46.9 75 VESA
XGA 1,024 x 768 48.4 6(1 VESA Guidelines
1,024 x 768 565 70 VESA
1,024 × 768 60.0 75 VESA
WXGA 1,28(I x 768 47.4 6(I VESA
1,280 x 768 47.8 6(I VESA
1,280 x 768 60.3 75
1,360
x
768 47.7 6(I VESA
SXG A 1,280 x 1,024 64.0 6(I VESA
HDTV 1,920
x
1,080 67.5 6(I C EA-861 *
• This TV's PC input does not support Sync on Green or
Composite Sync.
• This TV's PC VGA input does not support interlaced
signals.
• Your PC must support one of the above PC input
signals to display on the television.
• For the best picture quality, it is recommended to use
the signals (boldfaced) in the above chart with a 60 Hz
vertical frequency. In plug and play, signals with a 60
Hz vertical frequency will be detected automatically.
(PC reboot may be necessary.)
":The 1080p timing when applied to the HDMI input will
be treated as a video timing and not PC tinting. This
affects Picture settings, Wide Mode settings, and PiP
function. To view PC content set Picture Mode to
Custom, Wide Mode to Full, and Display Area to
Full Pixel.
14