Attaching The Handle - Craftsman 172.79183 Operator's Manual

ATTACHING THE HANDLE
The _handlecomes packaged in sections,which are connectedtogether by internalcoated
wiring ru_ningthroughthe middle of all the handle pieces.
• 1, Carefuily remove packingmaterialand plasticwPappingaroundtool and handle pieces,
being carefulto keep pieces connected.
2. Remove the Knobs and Curved Head Boltsfrom the plastic bag.
3, Remove the black plastic tube coating from the piece of wire between the Handle and
the Upper Tube (Fig.l). This willenable the bolttofit throughthe smaller diameterHandle.
4. Slide the Handle down into the end of the Upper Tube so the holes lineup (Fig. 3a).
Carefully insert bolt, beingca'refulto avoid coveredwire _nsidehandle shaft (Fig. 3b).
Fasten together by tighteningKnobonto Curved Head B01t.
5. Slide UpperTube down into LowerTube so that holes line up. De n_t removethe black
plastt_tube coatingfrom the wire at this¢onnecti(_n;Them are two positloP_s available for
adjustment-t0your pmlerred height (FigAa).=NOTE: When you fkst ir_sert t he bolt,
it may be necessary to wiggleit _amfully to get _ pastthe coated wire inside the
Tube. Fasten together with second,Knob and Cu_ed Head Bolt(Ftg.4b).
Fig.3b
Fig. 4a Fig. 4b
I
NOTE= Be sure the wire cane movessmoothl, down into the Lower Handle.Tube
While assembling. :_
• % H,¢l i ,,., r i ....... " . .
t
...._:CAUTION= NEVER .so aslta:rp objeot to move ¢oated wires oUt of the wayo
I
13