Epson Stylus NX105 Service Manual page 36

Epson STYLUS NX100/NX105/SX100/SX105/TX100/TX101/TX102/TX103/TX105/TX106/TX109/ME 300
Occurrence timing
Detailed phenomenon
CR position
• Power on
When turning on the power, the Carriage
cannot get out of home position.
• Anywhere
Occurrence
timing Detailed phenomenon
CR position
• Operation
An error is indicated on the LED and
STM or LCD.
• –
TROUBLESHOOTING
Table 3-2. Check point for Fatal error according to each phenomenon
Defective
unit/part name
3. Check if the Spring Cleaner Lever comes off from the
Lever Cleaner.
Ink System
4. Check the routing of the Waste Ink Tube.
5. Check if the Cap Assy is damaged.
Main Frame 1. Check if the Main Frame is deformed.
Table 3-3. Check point for the Maintenance request according to each phenomenon
Defective
unit/part name
Waste Ink Pads
Error Indications and Fault Occurrence Causes
Check point
Lever Cleaner
Cleaner Lever
Spring
Check point
---
Revision A
Remedy
3. Reassemble the Cleaner Lever Spring correctly.
4. Route the Waste Ink Tube correctly.
(Refer to Chapter 4 "Ink System" (p.77))
5. Replace the Cap Assy with a new one.
1. Replace the Main Frame with a new one.
Remedy
1. Change the Waste Ink Pads and initialize the
Waste Ink Pad Counter. (Refer to Chapter 5
"ADJUSTMENT" (p.100))
Confidential
36