Table of Contents
Advertisement
The FUJITSU PCI GigabitEthernet 4.1 or later drivers support:
Supported VIDs
Max number of VLAN interfaces
3.7.2 Setting Up the VLAN Interface
The VLAN interface is set up using the following procedures.
-
By setting the interface number to 1000 or greater, it is possible to distinguish VLAN interfaces from physical interfaces.
The three lower digits of the VLAN interface number: physical instance number
The upper digits of the VLAN interface number: VID (1 - 4094).
VLAN interface number = VID * 1000 + physical instance number
- VLAN Interface Setup Examples
-
Solaris 10 8/07 or later
-
To create a VLAN Interface of VID=2 for a physical instance having instance number zero, the following is used.
Refer to
3.3 Environment
-
To create a VLAN Interface of VID=231 for a physical instance having instance number three, the following is used.
Refer to
3.3 Environment
-
VLAN interfaces are displayed by the following command.
dladm show-link | grep fjgi
Example:
# dladm show-link | grep fjgi
fjgi0
fjgi2000
fjgi1
fjgi2
fjgi3
fjgi231003
In the above example, the VLAN interfaces are displayed as fjgi1000 (VID=1) and fjgi231003 (VID=231).
-
Solaris 11
-
To create a VLAN Interface of VID=2 for fjgi0 (this vanity name is net2), the following is used.
Refer to
3.3 Environment
dladm create-vlan -l ether-link -v vid
Example:
# dladm create-vlan -l net2 -v 2
Setting, and perform the procedure described. Use fjgi2000 as the driver name.
Setting, and perform the procedure described. Use fjgi231003 as the driver name.
type: non-vlan
mtu: 1500
type: vlan 2
mtu: 1500
type: non-vlan
mtu: 1500
type: non-vlan
mtu: 1500
type: non-vlan
mtu: 1500
type: vlan 231
mtu: 1500
Setting, and perform the procedure described. Use net2002 as the driver name.
1 - 4094
1024
device: fjgi0
device: fjgi0
device: fjgi1
device: fjgi2
device: fjgi3
device: fjgi3
- 38 -
Advertisement
Table of Contents
