Jump Starting - Honda Pilot Owner's Manual

Jump Starting

BOOSTER BATTERY
The numbers in the illustration show
you the order to connect the jumper
cables.
3. Connect one jumper cable to the
positive ( ) terminal on your
vehicle's battery. Connect the
other end to the positive ( )
terminal on the booster battery.
522
4. Connect the second jumper cable
to the negative ( ) terminal on
the booster battery. Connect the
other end to the grounding strap
as shown. Do not connect this
jumper cable to any other part of
the engine.
2009 Pilot
5. If the booster battery is in another
vehicle, have an assistant start
that vehicle and run it at a fast idle.
Start your vehicle. If the starter
6.
motor still operates slowly, check
that the jumper cables have good
metal-to-metal contact.
Once the vehicle is running,
7.
disconnect the negative cable from
your vehicle, then from the
booster battery. Disconnect the
positive cable from your vehicle,
and then from the booster battery.
Keep the ends of the jumper cables
away from each other and any metal
on the vehicle until everything is
disconnected. Otherwise, you may
cause an electrical short.