Table of Contents
Advertisement
1 Gett ing to kn ow you r ET 18 0
Peripherals tour
Headset operation
The table below describes the action of the Send/End button on the headset when
there's an active mobile phone connection. When there's no active mobile phone
connection or when the Phone application is turned off, the headset's Send/End button is
disabled.
Scenario
Incoming call
Ongoing call
Keypad module
The detachable keypad module let's you enjoy the one-hand operation of using
conventional mobile phones for dialing and composing SMS messages.
The module has the following dimensions—63 mm x 60.3 x 3.5 mm (length x width x
depth), with a 240 x 144 resolution rate. For your convenience, the keypad is illuminated
in dim lighting conditions.
NOTE: The keypad module is not included in the ET180 package contents; you need to purchase
this item separately.
To attach the keypad module to the device
1
Remove the callpad module from the device by sliding it in a downward motion.
2
Insert then press down the keypad module into its bay until it clicks into place.
The module connector (i.e., gold bars) underneath the module should be aligned
to its corresponding connector on the device bay.
12
Quick Press
Accept the call
Terminate the call
Action
Press and hold for > 2 sec.
Accept the call
Record the ongoing call
Advertisement
Table of Contents
