Fujitsu F9600 Interface Manual page 16

LinkPlus Interface Guide: Fujitsu F9600 Telephone System
Assign Features to Programmable Buttons
16
Note that the TYPE must be 3.
The other parameters in the brackets can be the default values.
Other related commands: CHA MLDT, DEL MLDT, DIS MLDT
Clear programmable buttons
The programmable buttons are probably assigned to a default button
pattern. Perform the following to clear all buttons (button 00 will not
be cleared since this is the prime-line button).
DEL MLPFB,[TNN:0],DN,ALL
Other related commands: ASS MLPFB, DIS MLPFB
Assign station name
If desired, use this command to assign a name to the extension.
ASS STNAM,[TNN:0],DN,NAME
Other related commands: CHA STNAM, DEL STNAM
This assignment assigns selected features to selected buttons.
ASS MLPFB,[TNN;0],DNV,BNO,FN,[BNO,FN],,,,,,[BNO,FN]
The Fujitsu PBX will reset a phone after you assign a feature to a
programmable button. Therefore the phone will be unusable for
possibly as long as 20 seconds.
If Autodial is to be utilized, Autodial keys FAB10 (
( ), FAB12 (
FCN +5 FCN +9
for the Autodial feature. Additionally, the Program Mode feature
must be assigned to a desk set Feature Access Button that is mapped
to the handset (E.g. FAB14/
information about which Feature Access Button can be utilized for
Program Mode.
), and FAB13 ( ) must be programmed
FCN +*
). See the key-map diagram for
LINE +8
), FAB11
FCN +4
PN: 1725-36134-001_E.doc