Advertisement
Table of Contents
Operator's Manual
CRRFTSMRNo
4.25 AMP
TRIMMER / EDGER
Model No. 989,799310
®
•
Safety
•
Assembly
•
Operation
•
Maintenance
•
Parts
Espafio|
CAUTION:
Before using this product, read Ibis manual and follow air its
Safety Rules and Operating Instructions.
NEED ASSISTANCE ?
CALL 1-800-339-8657
-Sears,-Roebuck and Co., Hoffman Estates, tL 60179 USA
IV_RCH 1998
Visil_uFCraftsman website: www.sears.comJcraftsman
PN 211868-R
Advertisement
Table of Contents
Related Manuals for Craftsman 989.799310
Summary of Contents for Craftsman 989.799310
- Page 1 Operator's Manual CRRFTSMRNo 4.25 AMP TRIMMER / EDGER Model No. 989,799310 ® • Safety • Assembly • Operation • Maintenance • Parts Espafio| CAUTION: Before using this product, read Ibis manual and follow air its Safety Rules and Operating Instructions. NEED ASSISTANCE ? CALL 1-800-339-8657 -Sears,-Roebuck and Co., Hoffman Estates, tL 60179 USA...
- Page 2 ....Parts Ordering ... back cover Adjustments ....FULL ONE YEAR WARRANTY ON CRAFTSMAN TRIMMER / EDGER. If this Craftsman Trimmer/Edger fails to perform properly due to a defect in material or workmanship within (1) year from the date of purchase, Sears will repair or replace it, free of charge.
- Page 3 at a safe distance. 6. EXTENSION CORD - Use only with an extension cord intended for outdoor 9. KEEP HANDS AND FEET AWAY from use. Match wire gauge to the cord rotatingline. Do not operate without length. See table below. A 2-wira cord guard attached.
- Page 4 than user maintenance should be per- 18. STORE idle trimmer indoors. formed by a Sears Service Center. Appliance should be stored in a dry, Damage or conditions caused high or IScked up place - out of the improper maintenance practices reach of _hildren.
- Page 5 REX DISPOSABLE CU'I-rING HEAD 4. With firm pressure push disposable stringhead onto carder until an audible INSTALLATION AND REMOVAL click is heard (Figure 4). NOTE: REX lines are uneven for ir_proved cutting INSTALLATION 1. Unplug unit. 2. Positionthe motor housing with the stringhead carrier (A) facing up "...
-
Page 6: Fig. 8
NOTE:Shaftmay be adjustedin trimming 2. Pushred button forward, and rotate or edging mode. shaft until it stops (Figure 8). EDGING CONVERSION 1. Grip shaft fi}mly. Fig. 8 KNOW YOUR TRIMMER / EDGER SHAFT LOCKING-- HANDLE BUTTON ASSIST RETAINER HANDLE "SSED PLUG SHAFT TRIGGER... -
Page 7: Fig. 11
CONNECT THE CORD occurs at proper cutting point. Aiways cut away from yourself. Do not pull 1. Ensure the cord is NOT plugged into trimmer in toward yourself. a receptacle before starling this pro- cedure. 2. Make a loop with 8"- 10" (20 - 25cm) of the end of the extension cord. -
Page 8: Stringhead (Figure 5)
Removal in the Assembly section. Fig. 13 Fig. 15 STRINGHEAD hazard and void the manufacturer's 1. Use Craftsman replacement REX warranty. Stringhead Stock No. 71-85631. 2. Unplug the power cord before clean- 2. Always clean dirt and debris from the...
Need help?
Do you have a question about the 989.799310 and is the answer not in the manual?
Questions and answers