Advertisement
NOTE: This work stand may
be adjusted from: 28" - 36" in
height with positive stops at
30", 32", 34", and 36". To ad-
just the stand's height, turn the
two red locking knobs counter
clockwise
to unlock them, then
pull out the left knob and fol-
low steps 3-4.
_,
DANGER:Make
sure
that your hand is always on
the setup adjustment
handle
until the two locking knobs are
locked in the holes. Failure to
obey this safety warning WILL
result in the Tabletop Assembly
falling down accidentally, which
may lead to death or serious
injury to yourself or to others.
6. To change the width of
the Tabletop Assembly
working
area, turn the
tabletop
assembly's
four clamping
knobs
counterclockwise
to
unlock them (Fig 7. i/o
Fig. 6).
7. After loosening
the table-
top assembly's
clamp
knobs, adjust the Tabletop
Assembly
to the desired
position
to mount your
power tool (Fig.8 i/o
Fig. 7).
Fig. 8
22335
ManualRevised
07-1203
Page 14
Advertisement
