Unpack Thepressure Washer; Carton Contents; Attach Handleand Accessory Tray - Craftsman 580.752840 Operator's Manual

Your pressure washer requires some assembly and is ready
for use only after it has been properly serviced with the
recommended oil and fuel.
6. Verify pump oil dipstick (A) has been installed into pump.
If you have any problemswith the assembly of your
pressure washer, please call the pressure washer helpline
at 1=800-222-3136.
UNPACK THEPRESSURE WASHER
1. Remove everything from carton except pressure washer.
2. Open carton completely by cutting each corner from top
to bottom.
3. Remove pressure washer from carton.
CARTON CONTENTS
Check all contents. If any parts are missing or damaged, call
the pressure washer helpline at 1-800-222-3136.
• Main Unit
• Handle
• High Pressure Hose
• Spray Gun
• Nozzle Extensionwith Quick Connect Fitting
• DetergentSiphoning Tube/Filter
• Bottle Bracket Wireform (2)
• PerfectMix
TM
Siphoning Unit/Tube
• Engine Oil Bottle
• Parts Bag (which includes the following):
• Operator's Manual
• Owner's Registration Card
• Bag containing 5 Multi-Colored Quick Connect
Spray Tips
• HandleFasteningHardwareKit (which includes):
• Carriage Bolt (2)
• Plastic Knob (2)
Become familiar with each piece before assembling the
pressure washer, identify all contents with the illustration on
page 6. if any parts are missing or damaged, call the
pressure washer helpline at 1-800-222-3136.
ASSEMBLING PRESSURE WASHER
Your Craftsman pressure washer will need assembly before
operation:
1. Fill out and send in registration card.
2. Attach handle to main unit.
3. Connect detergent siphon tube to pump.
4. Add oil to engine crankcase.
5. Add fuel to fuel tank.
7. Connect pressure hose to spray gun and pump.
8. Connectwater supply to pump.
9. Attach nozzleextension to spray gun.
10. Select/attach quick connect spray tip to nozzle extension.
Attach Handleand Accessory Tray
1. Place handle (B) onto handle supports (C) connectedto
main unit. Make sure holes (D) in handle align with holes
(D) on handle supports.
NOTICE It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
2. Place bottle brackets (E) facing outside over holes in
handle. Secure bottle brackets and handle with carriage
bolts (F) and plastic knobs (G). Tighten by hand.
.
insert multi-colored quick connect spray tips and other
supplied accessories in spaces provided on handle.