Antec Twelve Hundred User Manual
Hide thumbs Also See for Twelve Hundred:

Advertisement

Twelve Hundred
User's Manual
Manuel de l'utilisateur
Anwenderhandbuch
Manuale per l'operatore
Manual del usuario

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Twelve Hundred and is the answer not in the manual?

Questions and answers

Summary of Contents for Antec Twelve Hundred

  • Page 1 Twelve Hundred User’s Manual Manuel de l’utilisateur Anwenderhandbuch Manuale per l’operatore Manual del usuario...
  • Page 2 Disclaimer This manual is intended only as a guide for Antec’s Computer Enclosures. For more comprehensive instructions on installing the motherboard and peripherals, please refer to the user’s manuals that come with those components.
  • Page 3 Installing the Motherboard This manual is not designed to cover CPU, RAM, or expansion card installation. Please consult the motherboard manual for specific mounting instructions and troubleshooting. Before proceeding, check the manual for your CPU cooler to find out if there are steps you must do before installing the motherboard. Lay the case down so that the open side is up.
  • Page 4 SATA connector is designed to connect to a standard SATA connector on your motherboard. This will allow high speed external hard disk enclosures such as the Antec MX-1 to run at the same speeds as if the hard disk were installed inside the case.
  • Page 5 Connecting the Audio Ports (AC’97 and HDA) There is an Intel® standard 10-pin AC’97 connector and an Intel® 10-pin HDA (High Definition Audio) connector. You can connect either the AC’97 or the HDA connector, but not both at once, to your motherboard depending on the spec of the motherboard.
  • Page 6 External 5.25” Device Installation Note: The HDD cages each occupy three consecutive drive bays, and will block installation of larger devices such as optical drives, so please plan ahead before installing your drives. Remove both side panels per the instructions in Setting Up.
  • Page 7 Cooling System The Big Boy 200mm fan: Antec understands your desire for the coolest gaming system. That’s why the Twelve Hundred comes with a Big Boy 200mm blue LED fan. This fan has a three-speed switch that lets you choose the speed best suited to your need and a switch to turn on or off the blue LED.
  • Page 8 High if you choose to connect the fan(s) to a fan control device or to the Fan-Only connector found on some Antec power supplies. A fan control device regulates the fan speed by varying the voltage, which may start as low as 4.5V to 5V.
  • Page 9 There are two optional 120mm fan mounts—the side fan (on the left side panel) and the middle fan (at the rear end of the HDD cage). We recommend using Antec 120mm TriCool™ fans and setting the speed to Low. These two fans should be installed so that the air is blowing into the case.
  • Page 10 Side Air Filter – There is a filter located in the side fan bracket. It is located on the inside of the side panel, so you must open the side panel to access it. Remove the filter by sliding it out of the bracket. From time to time it will be necessary to wash the installed air filters.
  • Page 11 1-800-22ANTEC customersupport@antec.com Europe +31 (0) 10 462-2060 europe.techsupport@antec.com www.antec.com © Copyright 2008 Antec, Inc. All rights reserved. All trademarks are the property of their respective owners. Reproduction in whole or in part without written permission is prohibited. Printed in China.

Table of Contents

Save PDF