Ip Dhcp Relay Address; Show Ip Dhcp Relay - Allied Telesis AT-8000S Cli User's Manual

Command Mode
Interface Configuration mode (VLAN, Ethernet, Port-channel)
User Guidelines
DHCP relay must first be globally enabled before enabling DHCP snooping on an interface.
Example
The following example enables Dynamic Host Configuration Protocol (DHCP) relay features for an interface.
console(config)# interface ethernet 1/e6
console(config-if)# ip dhcp relay enable

ip dhcp relay address

The ip dhcp relay address Global Configuration mode command makes a DHCP server available for the DHCP
relay. Use the no form of this command to remove server from the list.
Syntax
ip dhcp relay address [ip-address]
no ip dhcp relay address [ip-address]
Parameters
•
ip-address —DHCP server IP address. Up to 8 servers can be defined.
Default Configuration
No server is defined.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example makes a DHCP server available for the DHCP relay.
console(config)# ip dhcp relay 1.1.1.10

show ip dhcp relay

The show ip dhcp relay User EXEC mode command displays the server address on the DHCP relay.
Syntax
show ip dhcp relay
Page 166
IP DHCP Relay