Epson Stylus Photo RX600 User Manual page 62

Tip:
You can restore color in your old photos. See page 67 for details.
1. Open the scanner lid.
2. Place your photo or document face down on the glass in the upper left corner
about 0.1 inch from the edges, as shown.
You can also place additional small documents or photos and scan them at the
same time.
3. Close the scanner lid.
Note:
If you place your photo or document against the edge of the glass, the edges of
your photo or document may not be copied.
To scan a thick document, you can remove the scanner lid. Turn
off the Stylus Photo RX600, and open the scanner lid completely.
Then disconnect the cord from the TPU connector and pull the lid
straight up. Turn on the Stylus Photo RX600 and gently press
down the original to keep it flat on the scanner glass as you scan.
When you're finished, be sure to turn off the Stylus Photo RX600
before replacing the scanner lid and plugging in the connector.
62
Scanning to a Computer
0.1 in
Move the photo or
document in about 0.1
inch from the edges
0.1 in