Panasonic Workio DP-190 Operating Instructions Manual page 23

No. Icon Contents
RESET Key
Resets each selected copy/
18
scan modes to default
settings.
SET Key
Sets the parameter(s) of
20
Function settings.
FUNCTION Key
Use when changing the paper
size, initial function values
22
(default values) and key
operator settings.
ALARM LED (RED)
Lights/Flashes when trouble
occurs.
Lights:
Machine detected a trouble
status
● No paper in the selected
tray or toner has run out.
24
● Machine detected trouble,
such as paper misfed or
jammed.
Flashes:
Machine detected an alarm
status
● No paper in the Tray.
(Tray not selected)
● Toner is getting low, etc.
When inputting a special character, press the "_/() ... " Key and use the (
26
Cursor Keys to select a character.
When changing the stored character, move the cursor ( ) back to the character
and press the CLEAR Key then input a new character.
DARKER/LIGHTER
Keys
To adjust the Manual
27
Exposure.
(See pages 25 and 46)
SCAN/FILE Key
29 Used for network scanning.
(See pages 46-50)
N in 1 Key
Selects N in 1 copy mode.
30
(See page 29)
REMOTE REMOTE COPY Key
COPY
32
Selects Remote Copy mode. (See page 53)
NOTE: To adjust the character brightness of the LCD display, press and while holding down
the CLEAR Key, keep pressing the ORIGINAL SIZE or COPY SIZE Key until the
desired brightness is achieved.
ORIGINAL SIZE : Lighter
COPY SIZE
No. Icon
19
21
23
25
Keyboard
Inputs the Station, Machine name(s) of the
parameter settings, etc. (See pages 47-51)
28
31
: Darker
Contents
Keypad
Sets copy quantities or
inputs the parameter(s)
of Function settings.
CLEAR Key
Clears the copy count in the
display.
ACTIVE LED (GREEN)
Flashes when machine is
active.
PRINT DATA LED (GREEN)
Flashes:
When receiving printing data.
Lights:
While printing.
/ )
DUPLEX Key
Selects a 2-Sided copy.
(See page 27)
DOUBLE EXPOSURE Key
Selects Double Exposure
mode. (See page 30)
23