Battery Installation; Lithium Battery Safety; Controls And Indicators - Mitsubishi Electric 3DC-100S Owner's Manual

3D Adapter

Battery Installation

The remote control requires one CR2025 lithium battery.
Emitter
1. Remove the cover.
2. Insert the battery, positive side up. Be sure the
retaining clip holds the battery securely.
3. Reinstall the cover.

Lithium Battery Safety

This product uses CR2025 Li/MnO2 lithium coin batteries.
WARNING: Lithium coin cell batteries pose a serious risk of injury if ingested.
Keep cells out of reach of children. If ingested immediately contact a physi-
cian or the National Poison Center at 202-625-3333.
CAUTION: Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type (CR2025).
CAUTION: Risk of fire and burns. Do not recharge, disassemble, heat above
˚ ˚
100 C (212 F), or incinerate. Keep battery out of reach of children.
Disposal. Dispose of used batteries promptly according to local recycling or
waste regulations.

Controls and Indicators

IR Sensor
POWER Light
3D STATUS Light
POWER Button
3D MODE Button
1
2
Lit when power is on.
Lit during 3D signal processing.
Allows manual override of auto on/off. Press to power
off the Adapter if it powers on when not needed,
Allows manual selection of 3D format conversion.
For assistance call 1(800) 332-2119
To remove the battery,
press on the
retaining clip.
Remote Control
Adapter
5