Table of Contents
Advertisement
Available languages
Available languages
WR-120 Owner's Manual
Troubleshooting:
Problem
No Power
No Sound
No Weather broadcast
when you press the
WEATHER/SNOOZE
button
The radio is not
responding properly
to weather alert
broadcasts
For Technical Support Contact:
Midland Radio Corporation
5900 Parretta Drive
Kansas City, Missouri 64120
Phone: (816) 241-8500
Fax: (816) 241-5713
E-mail: mail@midlandradio.com
Web site: www.midlandusa.com
page 9
Suggestion
Make sure the power adapter is securely plugged
into the back of the weather radio and into the
wall outlet.
Make sure batteries are installed in case of a
power failure.
Check VOLUME control to ensure volume is
turned up to an audible level.
Ensure the telescoping antenna is up and fully
extended.
If you are using an external antenna, ensure it is
connected properly.
Ensure the radio is set to the weather channel in
use in your area.
Contact the broadcasting station to ensure they
are presently broadcasting.
If in a metal structure, make sure you are close
to a window.
If in a weak signal area, you will need an
external antenna.
Check to see that you have programmed in the
correct S.A.M.E. code(s).
Check that the tower nearest you is
broadcasting.
www.midlandusa.com
Hide quick links:
Advertisement
Chapters
Table of Contents
Need help?
Do you have a question about the WR-120 and is the answer not in the manual?
Questions and answers
HOW CAN i REDO THE SET UP IF i MESSED UP?
To reset the setup on a Midland WR-120 weather radio:
1. Unplug the radio from the wall.
2. Ensure the batteries are good. If the display is blank, replace the batteries.
3. With the radio unplugged and working batteries installed, remove one battery.
4. While replacing the battery, press and hold the WEATHER/SNOOZE button.
5. Keep holding the button until the display shows that the WR-120 is reset.
6. Release the WEATHER/SNOOZE button and proceed with reprogramming the radio.
This will restore the radio to factory settings.
This answer is automatically generated
My power adapter has a voltage selector slide button. Which one do I choose? It is set for 6v, but I **** not sure it is powering the radio or just the batteries. The choices are 12v, 9v, 7.5v, 6v, 4.5v and 3v.
My radio is beeping intermittently, I have changed the batteries, and it is saying bad reception how do I fic this issue?