Printer Mechanism Removal - Epson Stylus COLOR 800 Service Manual

EPSON Stylus &2/25 800

3.13 Printer Mechanism Removal

1. Remove the units and assemblies by following the procedures described in Section 3.9.
2. Disconnect all the connectors and FFCs from the C202 MAIN board assembly.
3. Remove 4 screws (CB, 4x12, F/Zn) securing the printer mechanism to the lower case.
(Refer to Figure 3-37.)
4. Lift up the printer mechanism to remove it from the lower case.
Make sure the connectors are not cut when you install the printer mechanism.
Always hold the upper or rear part of the mechanism, and never touch the gears.
Do not forget to insert the sub ink drain pad into the printer mechanism before installing
the mechanism into the lower case. The mounting location is shown in Figure 3-38.
Tightening torque for the screws (CB, 4x12, F/Zn) = 4 ~ 5 kg-cm.
3-30
Figure 3-37. Printer Mechanism Screw Removal
Rev. A