1. Manuals
  2. Brands
  3. Centro Manuals
  4. Grill
  5. Barbecue 6500 Safe use
  6. Safe use, care and assembly manual

Centro Barbecue 6500 Safe Use, Care And Assembly Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

SERIAL #:
5 Y E A R L I M I T E D W A R R A N T Y
8 5 - 1 6 1 6 - 8 ( P R O P A N E ) ( G 6 1 0 0 6 )
8 5 - 1 6 1 7 - 6 ( N A T U R A L G A S ) ( G 6 1 0 0 7 )
Read and save this manual for future reference.
If pre-assembled, leave this manual with
unit for consumer's future reference.
For product inquiries, parts, warranty
and troubleshooting support, please call
1-877-707-5463
Barbecue 6500
S A F E U S E , C A R E A N D A S S E M B L Y M A N U A L
D A N G E R
If You Smell Gas
1. Shut off gas to the appliance.
2. Extinguish any open flame.
3. Open lid.
4. If odor continues, keep away from the
appliance and immediately call your
gas supplier or your fire department.
W A R N I N G
1. Do not store or use gasoline or other
flammable liquids or vapors in the
vicinity of this or any other appliance.
2. An LP cylinder not connected for use
shall not be stored in the vicinity of
this or any other appliance.
W A R N I N G
Failure to follow all of the manufacturer's
instructions could result in hazardous
fires, explosions, property damage,
or serious personal injury or even death.
W A R N I N G
Follow all leak check procedures carefully
prior to operation of barbecue,
even if barbecue was store assembled.
Do not try to light this barbecue
without reading the Lighting Instructions
section of this manual.
T H I S B A R B E C U E I S F O R
O U T D O O R U S E O N L Y

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Barbecue 6500 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Centro Barbecue 6500

Summary of Contents for Centro Barbecue 6500

  • Page 1 SERIAL #: Barbecue 6500 S A F E U S E , C A R E A N D A S S E M B L Y M A N U A L D A N G E R If You Smell Gas 1.

  • Page 2: Table Of Contents

    Warranty ....ii This Centro BBQ carries a five year limited warranty against defects in manufacturing work- Installation Information ..1 manship.

  • Page 3: Installation Information

    I N S T A L L A T I O N The installation of this appliance must be in accordance with all local codes, or in the absence of local codes: I N F O R M A T I O N Canadian installation must conform to the current national standards, which at this time •...

  • Page 4: Transportation And

    The Cylinder must also be equipped with: A shut-off valve with a correct cylinder valve outlet as specified in current standards. • Canada: CAN / CGA 1.6g-M97 Outdoor Gas Grilles. • a) A safety relief valve with direct connection to the vapour space of the cylinder. b) A collar to protect the tank shut-off valve.

  • Page 5: Prior To Using The Grill

    P R I O R T O U S I N G Do not use your barbecue until you have carefully read and fully understand all the information in this manual. Please ensure the following: Your barbecue is properly assembled. •...

  • Page 6: Safety Hose And Regulator

    S A F E T Y H O S E Propane Gas Models: Your barbecue is designed to operate on L.P. (Propane) gas at a pressure of 2.74 Kpa (11˝ water column). A regulator preset to this pressure is supplied A N D R E G U L A T O R with the barbecue and must be used.

  • Page 7: Safety Leak Testing

    To Reset The Gas Regulator Safety Device 1. Close the LP (propane) tank valve. 2. Turn all burner control knobs to the OFF position. 3. Disconnect the regulator from the LP tank. 4. Open the grill lid. 5. Open all of the control knobs to the high position. 6.

  • Page 8: Lighting The Main Burners

    L I G H T I N G Make Sure you have followed all the safety checks, procedures and instructions indicated in the previous section, before attempting to light the grill. T H E G R I L L Lighting The Main Burners 1.
  • Page 9 6. Confirm that the burner is properly lit. If the flame pattern is other than normal, consult the Troubleshooting Guide for corrective action. 7. Always preheat the Barbecue before starting to cook. Light all burners and adjust them to the HIGH position for 5-10 minutes. Before placing any food on the Barbecue, clean the cooking grids with a Porcelain cleaning brush.
  • Page 10 Lighting the Side Burner Use the Electronic Igniter on the main control panel and the Side Burner control knob, on the far left panel, to light the side burner. Push in and turn the side burner control knob to the HIGH position. •...

  • Page 11: Sear Zone

    When the BBQ is not in use, always cover the infrared burner with the Storage cover provided, to avoid burner damage caused by moisture or harsh weather. Purchase a Centro BBQ Cover to help protect your grill. Operating the infrared burner 1.

  • Page 12: Rotisserie Burner

    R O T I S S E R I E B U R N E R Turn all knobs to “OFF” • Open lid during lighting. Turn gas on at LP tank. • O P E R A T I N G I N S T R U C T I O N S Push in and turn the Rotisserie Burner Knob to the “ON”...

  • Page 13: Information On

    6. If a leak cannot be stopped, do not attempt to light the grill. Always contact Centro Customer Support for assistance. 1-888-707-5463. Gas Hookup & Warnings Warnings: Poor Natural Gas Burning Performance and heat distribution is related to the points listed below..
  • Page 14 All gas supply plumbing must be able to supply 7” water column to the barbecue with all burners in operation. ALL Centro BBQ’s are sold either NATURAL GAS or PROPANE READY and are not Convertible to an alternate gas source.

  • Page 16: Parts List And

    P A R T S L I S T I N G F O R 8 5 - 1 6 1 6 - 8 ( P R O P A N E ) ( G 6 1 0 0 6 ) Item No.
  • Page 17 8 5 - 1 6 1 6 - 8 ( P R O P A N E ) ( G 6 1 0 0 6 )
  • Page 18 P A R T S L I S T I N G F O R 8 5 - 1 6 1 7 - 6 ( N A T U R A L G A S ) ( G 6 1 0 0 7 ) Item No.
  • Page 19 8 5 - 1 6 1 7 - 6 ( N A T U R A L G A S ) ( G 6 1 0 0 7 )

  • Page 20: Assembly Instructions

    A S S E M B L Y I N S T R U C T I O N S Hardware Pack List Description Part Number Quantity Tools Needed for Assembly 1/4-20UNC x 38 Screw 20120-13038-250 1/4-20UNC x 13 Screw 20120-13013-250 ø7 Lock Washer 41400-07000-250...
  • Page 21 Fig. 1 Attach two front casters (EL) and two back casters with lock (EK) to the bottom shelf (EJ) using the provided wrench (#12). Fig. 2 For propane model ONLY (85-1616-8) Assemble the Tank base kit (EI) to the Bottom Shelf (EJ) as shown by using hardware #2 (X6) (from the top) and #3, #4, and #5 (X6) (from the bottom).
  • Page 22 Fig. 4 Assemble the upper brace (CJ) to the cart assemble which is already finished from the last 3 steps by using hardware #6, #7, and #8 (x4). Fig. 5 Place the top lid and burner box assembly (A+B) onto the cart assembly as shown.
  • Page 23 Fig. 7 Attach the warming rack (BP) to the back burner brace (BF) as shown. Make sure to insert the front 3 bars into the 3 holes of the back burn- er brace (BF). Place the two legs of the warming rack clip onto the edge of burner box weldment (BA).
  • Page 24 Fig. 10 Assemble the cart back panel (EC) to the back side of the cart by using hardware #1, #3, and #4 (x4). Assemble the tank exclusion wire frame to the bottom panel (EJ) and right side panel (EB) by using hardware #10, #11 and #12 ( x4) as shown.
  • Page 25 Fig. 13 Assemble the side burner shelf (DA) to the left upper side panel (EA) using hardware #1, #2, #3 (X3) and #4, #5 and #6 (X2). Assemble the side shelf (DI) to the right upper side panel (EB) by using the same hardware above.
  • Page 26 14.2 Fig. 14.2 Place the Digital System Assembly into the hole on the side burner control panel. Remember to place the Temperature probe into the hole first, as shown in the image. 14.3 Fig. 14.3 Use the ST3.0x10 Self-Tapping Screw (x4) to attach the Digital System onto the side burner control panel as shown.
  • Page 27 14.4 Fig. 14.4 Place the Control panel sticker onto the Digital System as shown. Place the temperature probe into the holding clip located under the Side burner Side shelf. The Digital System uses a 9V battery (x1) which is pre-assembled at the factory.
  • Page 28 14.5 Fig. 14.5 The end user must connect the wire from the load cell to the bot- tom side of the digital system box. The 3 load cells are located under this plate.
  • Page 29 Fig. 15 Remove the screws and washers from the door handles (EH) and assemble the handles to the left and right door (EF & EG) by using the same hardware provided on the door handles. Fig. 16 Unscrew the igniter cap and place AA battery which is provided into igniter (CF) with positive end (+) facing outward.
  • Page 30 Fig. 18 For propane model ONLY (85-1616-8) Secure 20lb propane tank onto the bottom shelf base (EJ) of the cart as shown, attach the regulator valve to 02lb propane tank. WARNING Do not store the extra tank into the cart. Fig.
  • Page 31 D I S T R I B U T O R Trileaf Distribution Trifeuil Toronto, Canada M4S 2B8...

Table of Contents