Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Zanussi ZWG 5120 P
Summary of Contents for Zanussi ZWG 5120 P
- Page 1 User manual Washing Machine ZWG 5120 P ZWG 5140 P...
-
Page 2: Table Of Contents
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 First use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 9 Frost precaution _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 Daily use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 10 Environment concerns _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4... - Page 3 • Install the appliance on a flat hard floor. wards for gelatinous detergents, with programmes in- cluding prewash, with the delay start option. In all • Never place cardboard, wood or similar materials un- these cases you can use metering balls or sachets der the appliance to compensate for any unevenness provided with the detergent, Take out the metering in the floor.
-
Page 4: Frost Precaution
To activate this device, ro- To disable this device tate the button (without and restore the possibili- pressing it) inside the ty of closing the door, ro- door clockwise until the tate the button anti-clock- groove is horizontal. If wise until the groove is necessary use a coin. -
Page 5: Product Description
This means that they can be recycled by disposing of • The machine works more economically if it is fully them properly in appropriate collection containers. loaded. • With adequate pre-treatment, stains and limited soil- Ecological hints ing can be removed; the laundry can then be washed To save water, energy and to help protect the environ- at a lower temperature. -
Page 6: Installation
Water supply pressure Minimum 0,05 MPa Maximum 0,8 MPa Maximum Load Cotton 6 kg Spin Speed Maximum 1200 rpm (ZWG5120P) 1400 rpm (ZWG5140P) Installation Unpacking Warning! • Read carefully the "Safety information" chap- ter before installing the appliance. • Remove the cardboard top. •... - Page 7 • Remove the power supply cable and the draining and inlet hose from the hose holders ( C ) on the rear of the appliance. • Plug the smaller upper hole and the two large ones with the corresponding plastic plug caps. Positioning and levelling •...
- Page 8 Firstly form a hook in the end of the drain hose using the plastic hose guide supplied with the appliance . The end of the drain hose can be positioned in three ways: • Hooked over the edge of a sink using the plastic hose guide.
-
Page 9: First Use
The drain hose may be extended to a maximum of 4 metres. An additional drain hose and joining piece is available from your Local Centre. Connections overview 115 cm 140 cm Electrical connection • Make sure that the mains plug and cable is not squash- ed or damaged by the back of the appliance. -
Page 10: Daily Use
Daily use Sort out the laundry Ball point pen and glue : moisten with acetone , lay the garment on a soft cloth and dab the stain. Follow the wash code symbols on each garment label Lipstick : moisten with acetone as above, then treat and the manufacturer’s washing instructions. - Page 11 Close the door gently If the water hardness degree is medium or high we sug- gest you to add a water softener following always the manufacturer’s instructions. Warning! Make When the degree of hardness is soft, readjust the quan- sure that any fab- tity of the detergent.
- Page 12 • Remove the drawer. Push the drawer edge out- • Pour the liquid detergent in the compartment wards where indicated by the arrow (PUSH) to fa- without exceeding the limit indicated in the flap. cilitate drawer removal. The detergent must be placed in the appropriate compartments of the dispenser drawer before start- The flap is down and you wish to use powder detergent: ing the wash programme.
- Page 13 Speciaal Katoen Temp. Spécial Coton Jeans +Voorwas Mini 30 +Prélavage 20° 1400 Hemden Zuinig Hoofdwas Chemises Lavage Extra spoelen Rinçage plus Antikreuk Synthetisch Einde Repassage facile Synthétique 30° 90° Centrifugeren Essorage 40° Pompen Fijne was 60° Vidange Délicats Wol/Laine Spoelen Handwas Rinçage Lavage à...
- Page 14 Spin Reduction By selecting a programme, the appliance proposes automatically the max- imum spin speed provided for that programme. 1400 Press this button repeatedly to change the spin speed, if you want your laundry to be spun at a different speed. The relevant light illuminates. Rinse Hold By selecting this function the water of the last rinse is not emptied out to prevent the fabrics from creasing.
- Page 15 Extra Rinse This appliance is designed for saving water. However, for people with very delicate skin (allergic to detergents) it may be necessary to rinse the laundry using an extra quantity of water. Press simultaneously the buttons 4 and 5 for some seconds: the pilot light 7.2 comes on.
-
Page 16: Washing Programmes
• Turn the programme selector dial to lector dial and any button are not touched, after a few minutes the energy saving system is enabled. The pilot • Select the draining or spinning programme. lights go off. The green pilot light of the button 6 flash- •... - Page 17 Programme - Maximum and Minimum Temperature - Cycle De- Detergent Com- scription - Maximum Spin Speed - Maximum Fabrics Load - Options partment Type of Laundry SYNTHETICS 60° - (Cold) SPIN REDUCTION , Main wash - Rinses - Maximum spin speed: 1200 rpm for RINSE HOLD , ZWG5120P - 900 rpm forZWG5140P DELAY START ,...
- Page 18 Programme - Maximum and Minimum Temperature - Cycle De- Detergent Com- scription - Maximum Spin Speed - Maximum Fabrics Load - Options partment Type of Laundry DRAIN Draining of water For emptying out the water left in the drum. SPIN Drain and long spin at maximum spin speed: 1200 rpm for ZWG5120P- 1400 rpm for ZWG5140P Max.
-
Page 19: Consumption Values
Consumption values Programme Energy consumption Water consumption (litres) Programme duration (Mi- (KWh) nutes) White Cottons 90° 2.10 Cottons 60° 1.20 1.02 Cotton ECO 60° Cottons 40° 0.75 Synthetics 40° 0.60 Delicates 40° 0.60 Wool/ Handwash 30° 0.30 1) «Cottons Eco» at 60°C with a load of 6 kg is the reference programme for the data entered in the energy label, in compliance with EEC 92/75 standards. - Page 20 • open the filter cover by pressing the special hook and by rotating the cover upwards; Warning! Keep the filter cover open un- til the filter removal. • before removing the fil- • Use a stiff brush to clean and remove all washing ter, remove any fluff or powder residue.
-
Page 21: What To Do If
the display (if available) shows the relevant alarm (see chapter "What to do if..." for more details), check if the water inlet filters are blocked . To clean the water inlet filters: • Turn off the water tap. • Unscrew the hose from the tap. - Page 22 Fault code and malfunction Possible cause / Solution The water tap is closed. Hoofdwas Lavage • Open the water tap. Extra spoelen Rinçage plus The inlet hose is squashed or kinked. Einde • Check the inlet hose connection. The filter in the inlet hose or the inlet valve filter are blocked. •...
- Page 23 The appliance does not start or stops during operation Before contacting your local Service Centre, please car- without any visible alarm. ry out the checks listed below. Malfunction Possible cause / Solution The plug is not properly inserted in the power socket. •...
- Page 24 Malfunction Possible cause / Solution The transit bolts and packing have not been removed. • Check the correct installation of the appliance. The appliance is not levelled correctly. The appliance vibrates noisi- • Adjust the feet. The laundry is not evenly distributed in the drum. •...
- Page 25 The necessary data for the service centre is on the rat- ing plate. We recommend that you write the data here: Mod..Prod. No..Ser. No..Model description ....... (MOD.) Product number (PNC) ....... Serial number (S.N.) .......
- Page 28 www.zanussi.com/shop...