Byron BY103 Installation And Operation Instruction

Plug-through
™
Wire Free Chime Kit
BY103
6:
4:
1:
5:
2:
:3
1: Push Button 5: Plug-through Chime
2: Melody Selector 6: Speaker
3: Bell Push Battery
4: Signal Sent LED
1
1: Place a small flat screwdriver
into the locking clip on the
base of the Bell Push.
2: Gently twist.
3: The backing plate will unclip.
2 1: Insert CR2032 battery
(Supplied) into the battery
holder.
2: Make sure the positive side
is facing upwards.
3: Replace back plate.
Warning: Make sure that the batteries are
replaced correctly to avoid battery failure.
Only replace with same or equivalent type.
1: Plug Chime into a UK 3pin
socket, 220 – 240V ~ 50Hz.
2: Switch the socket on.
4 4
1: The Chime will 'Beep Beep'.
2: Press the Bell Push within
60 seconds to learn the
Bell Push to the chime.
3: The Chime will ring to
confirm setup.
Note: Maximum of 2
Bell Pushes can be learnt to a
single Chime for Front/Back
Functions:
Melody selection:
To select a melody for the Door Chime
1: Remove the Back Plate from the Bell
Push.
2: Press the Melody Select button.
CR2032
3:The chime will play the newly selected
sound.
4: Press again to select the next melody.
Note: For Front/Back door setup, select a
different melody in one of the Bell Pushes.
4 Selectable Melodies
1: Ding Dong (Repeat) 3: Alarm
2: Westminster 4: Ding Dong Ding
Plug-through Socket:
3
Plug-in any standard electrical product,
220–240V ~50Hz.
e.g. table light, upto a Max Load of
1000W
Avoid using low voltage Transformers, as
this may reduce the operating range of
the Door Chime
Adding Additional Chime/Bell Push:
New Chime
Additional Chime
To add an additional Chime unit to the Door Chime kit
1: Unplug the NEW Door Chime and wait for 10
seconds
2: Plug the Door Chime into the Socket and switch the socket On.
3: The Chime will 'Beep Beep' to indicate that it has entered
the Learn mode.
4: Press the Bell Push within 60 seconds, to pair the additional
Chime to the Bell Push.
5: Chime will ring to confirm setup, wait 60 seconds for the Chime
to exit the learn mode before repressing the Bell Push.
Additional Bell Push
To add an additional Bell Push to the Door Chime kit
1: Unplug the Door Chime and wait for 10
seconds.
2: Plug the Door Chime into the Socket and
switch the socket on.
3: Press both Bell Pushes within 60 seconds, to pair
the additional Bell Push to the Chime.
4: Chime will ring to confirm setup, wait 60 seconds
for Chime to exit the learn mode before repressing the
Bell Push5.
5: For Front/Back door setup, select a different melody in one of the
Bell Pushes - See Melody Selection.
Note: Maximum of 2 Bell Pushes can be learnt to a single
Door Chime.
Front Door
Back Door