IMPORTANT SAFETY INSTRUCTIONS WARNING FOR YOUR PROTECTION PLEASE READ THE FOLLOWING: KEEP THESE INSTRUCTIONS HEED ALL WARNINGS FOLLOW ALL INSTRUCTIONS THE APPARATUS SHALL NOT bE ExPOSED TO DRIPPING OR SPLASHING The symbols shown above are internationally accepted symbols LIqUID AND NO ObjECT FILLED WITH LIqUID, SUCH AS vASES, SHALL that warn of potential hazards with electrical products.
• including interference that may cause undesired Date: February 1, 2008 operation. European Contact: Your local BSS Audio Sales and Service Office or Operation of this unit within significant Harman Music Group electromagnetic fields should be avoided. 8760 South Sandy Parkway Sandy, Utah 84070, USA use only shielded interconnecting cables.
This equipment must be earthed. It should not be necessary to remove any protective earth or signal cable shield connections to prevent ground loops. Any such disconnections are outside the recommended practice of BSS Audio, and will render the EMC or safety certificate void.
Front panel Input card monitoring Each channel has 3 LED indicators showing: Clip Illuminated - Indicates clipping in the analogue domain for each channel of the fitted Input or Output card. The LED will illuminate at +18.5dB. Signal Illuminated - The Signal LED will illuminate for each channel of a fitted Input or Output card when the signal reaches or exceeds the signal threshold of -20dB.
Page 6
Audio cable wiring All audio and control connections to the BLU-800/BLU-320/BLU-160/BLU-120 are via Klippon pluggable terminal block connectors (also known as BL, Phoenix or Combicon). 6-way female Klippon connectors are supplied for making these connections. Audio Input and Output wiring convention Soundweb products provide cable shielding ‘back from the destination’...
BUDDYLINK / 48K ETHERNET LOCATE RS232 MANUFACTURED IN THE USA BY BSS AUDIO AC Mains AC Mains input to the universal switched-mode power supply, operates over a wide range of AC input voltages from 100V to 240V, 50/60Hz. CobraNet Connectors - Primary/Secondary...
Page 8
I/O Card Positions A, B, C and D These connectors provide the balanced connections for the I/O card fitted in the four card slots in a Soundweb London device. A green LED next to the slot assignment letter A, B, C or D indicates that an Input card is fitted and an amber LED when an output card is fitted.
Page 9
OPTO Output In addition to the eight standard logic outputs, there is an isolated output, which fails safe (open circuit) if the unit becomes faulty. 47kOhm 10K-100kOhm linear unconnected lad- lad- switch switch 2 wire mode 3 wire mode +supply relay relay ground...
Technical specifications FRONT PANEL LED INDICATORS Per Input: Signal Present, CLIP, SYNC/48V, I/O card type (IN, OUT, DIG, AEC(BLU-800, 320, 160, 120)) Other: LCD Display, Conductor active, Net Link active, Data Activity ANALOGUE INPUTS: Up to 16 electronically balanced on Phoenix/Combicon removable screw connectors Mic/Line Inputs: Nominal gain 0dB, electronically switchable up to +48dB,...
Page 11
Please contact BSS Technical Support for more information on purchasing replacement parts or product service. BSS Audio has a policy of continued product improvement and accordingly reserves the right to change features and specifications without prior notice.
Need help?
Do you have a question about the Soundweb London BLU-120 and is the answer not in the manual?
Questions and answers