Resetting The Switch - Cisco IE-3000-8TC Getting Started Manual

Checklist
Did you have a wireless client
running on your PC when you
connected to the switch port?
Do you need to change the switch IP
address after you have already
completed the initial setup?

Resetting the Switch

Caution
Cisco IE 3000 Switch Getting Started Guide
26
Recommendation
If yes, disconnect the cable from the switch port, disable the
wireless client, press the Express Setup button, and reconnect the
cable to the blinking Ethernet port.
Go to the Configure > Express Setup device manager screen to
change the switch IP address. For more information about
changing the switch IP address, see the switch configuration
guide online at Cisco.com.
Follow these steps to return your switch to the factory default settings. These are
reasons why you might want to reset the switch:
• You installed the switch in your network and cannot connect to it because you
assigned the wrong IP address.
You want to clear all configurations from the switch and assign a new IP
•
address.
You want to reset the password on the switch.
•
Resetting the switch deletes the configuration and reboots the switch.
To reset the password on the switch:
Power off the switch.
1.
Power on the switch, and at the same time, press and hold down the Express
2.
Setup button until all the system LEDs turn red.
Release the Express Setup button, and the switch continues to boot.
3.
After the switch restarts, continue to run Express Setup.
Cisco IE 3000 Switch Getting Started Guide
OL-16234-01