Troubleshooting; Please Do Not Return This Product To The Store; Heat Indicator Light Does Not Illuminate; Reduced Or No Spray - Bissell Proheat 25A3 SERIES User Manual

T
roubleshooting

Heat indicator light does not illuminate:

Possible causes
1. The heater switch is not turned on.
2. The machine power switch is not turned on

Reduced or no spray

Possible causes
1. Bladder may be empty.
2. 2-in-1 tank may not be seated properly.
3. Pump may have lost prime.
4. The pump belt may be broken.
Other maintenance or service not included in the manual should be
performed by an authorized service representative.
Thank you for selecting a BISSELL product.

Please do not return this product to the store.

For any questions or concerns, BISSELL is happy to be of
service. Contact us directly at 1-800-237-7691.
16
w w w . b i s s e l l . c o m
a.
b.
Slots Pump Belt
Remedies
1. Turn on the heater switch located on side of unit
2. Both switches must be on to activate the
heat indicator light.
Remedies
1. Refill bladder with hot tap water
2. Remove and reseat 2-in-1 tank
3. Turn power off and hold spray trigger for 30 seconds. Turn
machine back on and check for spray
4. Turn power switch off and unplug
from the outlet. To check if a pump belt has
broken, you will need a flat head screwdriver.
a. Insert the flat end into the slot of the
belt access door to release. Examine the
belt for breakage. You should be able to see
the pump belt looped around the motor shaft.
If it is broken or missing, please refer to
Replacement Parts on page 17.
A replacement belt may be ordered at
www.bissell.com or by calling BISSELL
Consumer Services at 800-237-7691.
Complete installation instructions will accompany the
replacement belt.
b. When replacing belt access door be sure to
line up slots of belt access door with slots in
machine, slide door into place and snap shut.
8 0 0 . 2 3 7 . 7 6 9 1