The Wash Programme Stops And A Fault Indicator Light Comes On - Miele W 2514 WPS Operating Instructions Manual

The wash programme stops and a fault indicator light comes
on.
Problem
The buzzer sounds and
the Drain CHECK light
flashes. "– – –" appears
in the display.
The buzzer sounds and
the Inlet CHECK light
flashes. "– – –" appears
in the display.
The buzzer sounds and
the Inlet and Drain
CHECK light flash.
"– – –" appears in the
display.
The buzzer sounds and
the Soak or Rinses
SEQUENCE indicator
lights flash. "– – –"
appears in the display.
A To delete the fault message: Switch the washing machine off with the I-On/0-Off
button.
Possible cause
The water outlet is
blocked or restricted.
The drain hose has
been fixed too high.
The water inlet is
blocked or restricted.
The filter in the water
inlet hose is dirty.
The Miele Waterproof
system has reacted.
There is a fault.
Cleaning and care
Remedy A
Clean the fluff filter and the
drain pump as described in
"Problem solving guide –
Opening the door in the
event of a blocked drain
outlet or a power failure".
The maximum drain height is
1 m.
Check whether
– the stopcock is opened
wide enough.
– the inlet hose is kinked.
Clean the filter.
Call the Service Department.
Start the programme again.
If the fault message appears
again, contact the Service
Department.
35