Advertisement
high fidelity engineering
since 1974
Ensure your unit is switched off and that the volume
control knob is at its minimum.
Please note that your 1010 Integrated Amplifier
may take up to 48 hours to "run-in" before reaching
its optimal performance. Each subsequent "run-in"
will then take about 30 minutes.
The Exposure 1010 Integrated Amplifier is fitted
with an over current sensor which will switch off the
speaker output in the event of a speaker wire short
circuit or excessive current. To reset the output,
switch off the Amplifier for 5 minutes.
Advertisement
Table of Contents
Related Manuals for Exposure 1010
Summary of Contents for Exposure 1010
- Page 1 48 hours to “run-in” before reaching its optimal performance. Each subsequent “run-in” will then take about 30 minutes. The Exposure 1010 Integrated Amplifier is fitted with an over current sensor which will switch off the speaker output in the event of a speaker wire short circuit or excessive current.
Need help?
Do you have a question about the 1010 and is the answer not in the manual?
Questions and answers