Stopping A Backup Or Recovery In Progress - LaCie 301160U - 1TB Ethernet Disk RAID Network Attached Storage User Manual

LaCie Ethernet Disk RAID
User Manual

7.4. Stopping a Backup or Recovery in Progress

Once a backup or recovery starts, you can stop it at
any time – for example, if you notice that your system is
not responding as quickly as you' d like, and you want to
free up processing capabilities for other tasks.
When you stop a backup in progress, that backup
won't appear in the list of backups on the Restore page,
and any changed data that was not copied to the Ether-
net Disk RAID will be copied during the next backup.
When you stop a recovery in progress, the local disk
or partition is left in an incomplete state, and you must
recover it again later before you can use it.
To stop a backup or recovery in progress:
1. Click Status.
2. In the Protected disk
backup or recovery you want to stop.
3. Click Stop Current
backup, the backup stops immediately.
If you're stopping a recovery, a confirmation message
appears. Click
Cancel to proceed with it.
list, select the disk whose
Activity. If you're stopping a
OK to stop the recovery now, or click
Protecting Local Disks
Fig. 7.4.
page 0