Preparation Before Use - JVC GV-LS2W User Manual

Preparation before Use

Connecting the Camera to
Your Computer
To set up the camera, fi rst connect it to
your computer.
Required operating environment
Browser: Internet Explorer 9 or later
1 Attach the supplied LAN cable to
the camera.
RESET
ETHERENT
2 Connect the camera to your
computer via the supplied LAN
cable.
3 Set the network mode switch to
[LAN•OFF].
DIRECT WLAN LAN(OFF)
• If the network mode switch is set to
[DIRECT] or [WLAN], the LAN terminal
cannot be used.
• While the power is on, switching the
network mode switch does not change
the setting.
• Do not use cables (AV cable,
microphone, etc.) with L-shaped
connecters.
• For other ways of connecting, see
"Detailed User Guide".
For more details, refer to the Detailed User Guide at http://manual3.jvckenwood.com/
MIC
DC
DIRECT WLAN LAN(OFF)
AV
MIC
RESET
DC
DIRECT WLAN LAN(OFF)
AV
ETHERENT
Connecting the AC Adapter
Connect the supplied AC adapter to the
DC connector of the camera.
AC adapter
Configuring the Camera Settings
Appropriate for Your Needs
Specify the video format, zoom, etc.
appropriate for your needs. Confi gure the
settings on a browser.
Logging in as an administrator
1 If the power is not turned on, press
and hold the [POWER] button to
power on.
The [POWER] button starts blinking.
Wait until it stops blinking and stays lit.
2 Set the Network Setting of the
computer as follows.
IP Address: 192.168.1.2 to
192.168.1.254 (except 192.168.1.100)
(example) 192.168.1.23
Subnet mask: 255.255.255.0
Make a note of the current network
settings before operation for resetting
the network setting.
3 Start Internet Explorer, and enter
"http://192.168.1.100:8000" in the
address bar.
MIC
RESET
DC
DIRECT WLAN LAN(OFF)
AV
ETHERENT
Conversion cable
9