Care And Maintenance; Resetting The Scanner; General Use; Location - Uniden BC75XLT Owner's Manual

CARE AND MAINTENANCE

RESETTING THE SCANNER

if the scanner's display locks up or stops operating properly,
you might need to reset the scanner.
CAUTION: This procedure clears all the information
you have stored in the scanner . before you reset
the scanner, try turning it off and back on to see if
it begins working properly . Reset the scanner only
when you are sure it is not working properly .
1. Turn off the scanner.
While holding down 2, 9, and Hold, turn on the scanner.
2.
it takes about 3 seconds to initialize and CLEAr appears.

GENERAL USE

• Turn the scanner off before disconnecting the power.
• Always write down the programmed frequencies in the
event of memory loss.
• if memory is lost, simply reprogram each channel. The
display shows 000.0000 in all channels when there has
been a memory loss.
• Always press each button firmly until you hear the entry
tone for that key entry.

LOCATION

• do not use the scanner in high-moisture environments
such as the kitchen or bathroom.
• Avoid placing the unit in direct sunlight or near heating
elements or vents.
53