Setting Up Storage For Apple Mac Os X; Iscsi Initiator Setup For Linux; Installing And Configuring The Suse Linux Enterprise 10 Iscsi Driver; Presented Eva Luns - HP StorageWorks 6100 - Enterprise Virtual Array User Manual
Hp storageworks mpx200 multifunction router user guide (5697-0306, january 2010)
Hide thumbs
Also See for StorageWorks 6100 - Enterprise Virtual Array:
- User manual (462 pages) ,
- User manual (232 pages) ,
- User manual (186 pages)
Table of Contents
Advertisement
Setting up storage for Apple Mac OS X
1.
In HP Command View EVA, present the LUNs.
2.
Verify that the EVA LUNs are presented to the Xtend SAN iSCSI Initiator:
a.
Open the Xtend SAN iSCSI application.
b.
Select the MPX200 target entry under the host name.
c.
Click LUNs.
A list of presented EVA LUNs is displayed
Figure 43 Presented EVA LUNs
.
NOTE:
If no LUNs are displayed, log out and then log in again to the target, or reboot the system.
3.
Set up the iSCSI drive on the Xtend SAN iSCSI Initiator:
a.
Open Disk Utilities from the Apple Mac OS X Finder Applications list.
b.
Format and partition the EVA LUN, as needed.
iSCSI initiator setup for Linux
Installing and configuring the SUSE Linux Enterprise 10 iSCSI driver
Configure the initiator using the built-in GUI-based tool or the open-iscsi administration utility using
the iscsiadm command. See the iscsiadm (8) man pages for detailed command information.
66
MPX200 iSCSI configuration rules and guidelines
(Figure
43).
Advertisement
Table of Contents
Troubleshooting
